tranny question?

[protsi]

it is possible to run B4 trans in old rc10

maybe new shock tower with hole for the wing and hold the trans or something close?

[jwscab]

there are a bunch of threads where guys have done that pretty easily.

you would need to either cut a hole in the bottom of the chassis, or mount the trans on a small plate with a hole to allow the trans to sit 'flat' on the chassis, and then modify the bulkhead or fab a new rear bulkhead. you may also need to trim some of the chassis or bend some small plates to attach the motor plate, and perhaps a bracket to help tie into the rear bulkhead.

[protsi]

there are a bunch of threads where guys have done that pretty easily.

you would need to either cut a hole in the bottom of the chassis, or mount the trans on a small plate with a hole to allow the trans to sit 'flat' on the chassis, and then modify the bulkhead or fab a new rear bulkhead. you may also need to trim some of the chassis or bend some small plates to attach the motor plate, and perhaps a bracket to help tie into the rear bulkhead.

thanks for the reply... it is possible for you to re direct me to those treat to see the correct one I have a graphite chassis? thanks

[soniccj5]

You might want to check out Toasted Coasties build.

http://www.rc10talk.com/viewtopic.php?f=35&t=16956&hilit=b4+transmission&start=15

[protsi]

You might want to check out Toasted Coasties build.

http://www.rc10talk.com/viewtopic.php?f=35&t=16956&hilit=b4+transmission&start=15

thanks