RC10Talk - The Net's Largest Vintage R/C Community

Err no I do some work with fluid dynamics instead. I take lots of money and flush it down the toilet on rc cars, but it's so much fun!

Hey thanks for the compliment! I was looking at those scales on ebay too! I think I may go the cheap route and pick up 4 pocket sized gram scales from Harborfreight. Since my main concern is front-rear weight I'm not worried about wedge/crossweight or left side weight. Let us all know how they work ...

Think i got this pic posting thing nailed!

Hey all, I built a gold pan complete with sc10/b4 hex conversion in the front and xxx-cr rear hubs and dynotech rear arms. I plotted the roll center on vsusp (a free utility I found online) and found its about 11mm above ground at ride height 24mm and goes to 12mm under ground with ride height 0mm. ...

I used a b4/t4 motor plate and drilled/ tapped new holes in it along with dremeling some gold pan trans spacers for my electric conversion. I got the plate and v2 slipper and top shaft et cetera from the ebays and even got the gear cover to fit. Hooray safety! have not run the truck yet, got caught ...

Yes! Those are the business! i have been wanting to do a transverse steering servo to move the battery forward anyway! I had started filing and grinding on a b4 bellcrank set but i was worried about the posts bending and didnt want to add a top brace. is it typical to have the battery as far forward...

So I built a beat A stamp car into the CE I had as a kid, but with 12mm hexes and the trackwidth pushed out to ROAR maximum. Im using RPM ballcups and the newer style associated ball studs on the front and am having a problem with the inner camber link and inner tierod rubbing,. is there a shorter b...