RC10Talk - The Net's Largest Vintage R/C Community

Haha, thanks

They are still sitting comfortably in my curio cabinet with some other unicorns in my collection...

One of my own builds, but it makes me happy looking back at the build!

This one makes me really happy especially since I've been out of stock for quite a while

Yes, hopefully by mid week. We had JC Racing repair and update our mold before running these for us. They are in transit now

Gearbox time !! I bought another 4620 diff for this truck and I attempted to drill out the output shafts which I wanted to do with my race SRT. Needless to say it turned out a lot better then I was expecting. 20240309_221441.jpg This diff feels better than the other two tra**as diffs that I built, g...

The early tra**as gear cover wouldn't fit so I had to come up with another option, why not try a B4 gear cover of all things? Sure enough it fit with a bit of drilling and tapping and it clears a large 87 tooth spur so plenty of gear options. 20240309_224312.jpg I'm not sure if this will be the moto...

Yep!

Design flaw. The Traxxas ESC switch does not fit in the Traxxas car.

Just popped the switch out of its case, and just going to run it exposed. I think its water and dirt days are over, so I don't think it will be an issue. The servo mount could have been trimmed enough, and still be plenty strong, so there is also a different route. The XL-1 may end up being too tall...

Yikes. Time. Passes. Anyway, apologies for cannibalizing a rear Eagle/Bullet tower. Too much MacGuyver bitd, I guess..

I had an x-acto knife (Jconcepts handle) roll off the end of my table and land upright into the top of my bare foot. The weight of the handle meant the entire length of the blade went into my foot. I stared at it for a second because I couldn't believe it had just happened. :shock: this happened to...

Paint by me, body by Boki!

I think the chances of coming across that Ko Propo servo are pretty slim but it was the only part that was really holding this project up, so I threw in a placeholder to wrap things up. Eleven years after starting this project, it is hard to believe I am finally in the home stretch….did some work th...

I might be remembering wrong but I think Vectorsolid is Bob Stormer.