RC10Talk - The Net's Largest Vintage R/C Community

Pretty neat. I'm gonna have to open it though

The exhaust port was installed, and I connected a pipe to an Xtool AP2 air purifier. I got the laser combo as my wife has some light requirements for a laser. Laser module installation is very straigth forward : you just have to put the module in place, plug it, plug the air assist tube on the modul...

I procrastinated a lot recently... The publication for the 312 bodyshell accessories is still awaiting I do the instruction manual, and I had to finish the 917K accessories... I defined the cut line for both arches and the side line. A printed part will do the job... https://i.imgur.com/8ykSM7z.jpeg...

Just published an alternative battery fixation allowing for quick release...
https://makerworld.com/en/models/1466375-battery-quick-release-for-st-1-ef-209-rc-pancar

The principle is simple, it replace the bridge I implemented initially with 2 parts and a reusable cables tie with scratch...

Finalizing the files takes time. I first added all hardware in Fusion360, then made the joints, then organized and then took snapshots... https://i.imgur.com/tnD3vvf.png https://i.imgur.com/xk7uhsB.png And all this to make a simple instruction manual... A few hours of work! The 917K should be quicke...

It's a bit too hot right now to do something else, so I finalized the 917K and published it. Again same process than for the others was applied... https://i.imgur.com/yEwKH89.png https://i.imgur.com/uK5boO1.png The accessories for the Delta Plastik Porsche 917K (available at Mantua Models) are now p...

The Zerda ran at Montluçon few weeks ago. But it was with the main belt longer than what was required, with adjustment of the tightener rollers diameter to make it fit. The proper belt arrived the day before Montluçon, and I had no chance to change it before the event or during the event. I decided ...

Well...I might have done something.

The 917K required some colors... I thought about red/white, green purple and blue orange, and that's the last one I chose...

Normally, the 917K should be ready for Belley

No Fox Given





Build thread here:
https://www.rc10talk.com/viewtopic.php?t=50554

A classical use of the simple characteristic "PLA and PETG don't stick together" T7G7skJAPx0 Bambu Lab PLA Matte white as Support interface (3 layers, 0 gap in Z) Sunlu PETG transparent with Generic PETG profile Worked like a charm, no oozing, no cross material pollution. Beside the suppor...

No disrespect intended, but that gearbox really gives me the impression of some type of barnyard animal.

Moo + Oink = Moink?
. .

Not going to bore you with the details, just a real nice piece. One of my favorites. Click on pics for details.

Composite Craft Predator Lynx NIB build (vintage runner), thread here: https://www.rc10talk.com/viewtopic.php?f=135&t=49813