RC10Talk - The Net's Largest Vintage R/C Community

Here are the "not promised" :D pictures of the B4.2 slipper and B4 cover on my "new" RC10. http://farm9.staticflickr.com/8096/8597332121_fde0935b2d_c.jpg http://farm9.staticflickr.com/8505/8598433830_b3ca16ed70_c.jpg Heya what gear cover part# is that!? I'm digging, I think I ne...

The current RPM covers clear the B4 slipper. BOKI (ebay) has some that look similar to original translucent ones but are redesigned for clearance.

With my set, I also threw in sets of diff balls and tie bolt thrust balls from McMaster Carr along with the rings. I was struggling with getting the diff smooth and flipped over the McM rings once. Now butter smooth. Maybe they have one side smoother than the other? I haven't run my 10T yet so no co...

I'm throwing this together at the request of another member. This is just some of the stuff that I do, so take it for what it is. If someone has any ideas to add, please do so. I rummaged through my stuff and found this crusty Peak Racing 12X2. It looks like a good candidate. Screenshot_20220416-133...

Somehow I skipped a step. There must be too many images because it wouldn't let me add more.

After painting the can, before reassembling the endbell, I polished the brush hoods. I used a rotary tool with a nylon brush wheel, with Brasso.

I believe you can get can decals from MCi, not positive it was them but regardless, very nice work, I have a ton of brushed motors and a cobra lathe, lets just say I need to get to work myself.......

RC4X4 wrote: ↑Sat Apr 16, 2022 3:31 pm I believe you can get can decals from MCi

Yes, I have a few laying around. Most of these are from MCI.

While waiting for the paint to dry, I decided to rehab the brushes as well. I was just going to put new ones on but these were in good condition and it goes with the thread. I crimped and soldered new terminals on. These are #4 hole, 18-22 gauge, from ebay. Screenshot_20220416-144336_Gallery.jpg I t...

Got it back together. Whoever was in this motor before, had the armature endplay way too tight. I adjusted the endplay and centered the armature in the magnetic field. I reassembled it with new Trinity springs and the old brushes. I checked rotation before installing the decal, so that everything wo...

cerakoting has been kinda popular in the 2A realm for a little while now. A guy who built some of my rifles checked into it and started off with a 'starter' kit...which snowballed into some major $$ for him with inconsistant results. In the end he now sends most of his stuff out to get done. He foun...

The Dom.

My 2022 VONATS RC10 Team Car with: RPM Worlds Front End, RPM bumper Hand Dremeled front and rear carbon fiber shock towers NIX RPM Bandit rear arm conversion Airtronics 94737 Servo, Hobbywing XR10 Justock ESC, Trinity XFactor 17.5 motor JConcepts Octagon tires, JConcepts Mono Wheels, JConcepts Prote...

My current vintage racers

Build thread is here:
https://www.rc10talk.com/viewtopic.php?f=35&t=46671

Now I just need a motor and some matches for that rocket...
. .

RC10 E-GT conversion. Picked up a cheap slider and mostly used stuff that was laying around to finish it. Ed (Frankentruck) hooked me up with a 3D battery tray and chassis plug. Truck is fairly basic, with a Dynotech motor plate. I used some ECX shocks (AE springs) that were removed from my Torment....