RC10Talk - The Net's Largest Vintage R/C Community

The #2520 came with two gears, one small which is the same as a stealth diff gear, and the other larger.

I can take a picture of it if you like.

Team Associated RC10B3.

Here you go.

Looking down the front straight at Indy.

Made a CF camber link drop/adapter plate for a project. It's on black, so it doesn't "pop". The final will be with white parts.

Running out of nice days here so I finished up the fox with some tamiya purple (sure looks blue!) and snapped a couple pics.

For a shelfer build! BNIB!

Have you ever experienced any printing issues with different nozzles? I tried a steel nozzle for wear resistance and I think it affected nozzle heating and layer bonding significantly. Adjusting nozzle temperature had minor improvement. After changing back to brass, my part strength is back to prev...

Rainy day here, so I disassembled, cleaned and lubed the transmission on my 6-gear runner....After my latest runs, I figured it at least needed an inspection.

Not exactly in the post today, maybe 2 - 3 weeks ago but I only took it out of the box today. I bought a Buds Motor Analyzing Dyno to set up a motor station. I know it reads some sort of RPM likely based on voltage but I'd like to set up an optical RPM read out to get a more accurate reading. I also...

So I got this thing together the other week. I wanted to get it on track before the end of the outdoor season, figuring that track would be a little more forgiving than some of the indoor places I'd be able to get to over the winter. I threw some electronics in it temporarily, so disregard the long ...

JC has molded the conversion box I created that uses a B6 ball or gear diff and a DR10/SR10/RB10 slipper. This case will allow the buyer to bolt it right into any RC10 as it has both stealth and 6 gear holes, and will fit either trans brace. Keep an eye on their website for these

while this is only a 2 wire servo I think this will look good on a future shelf car. And for 12 bucks it was too hard to pass up.

Frankentruck wrote: ↑Wed Nov 15, 2023 3:24 pm

LowClassCC wrote: ↑Wed Nov 15, 2023 2:10 pm while this is only a 2 wire servo I think this will look good on a future shelf car. And for 12 bucks it was too hard to pass up.

20231115_140133.jpg

Very nice! Who makes that servo? Any mode number?

Solarbotics GM4

I bought it through Banana Robotics. Shipping was like 5 bucks.