RC10Talk - The Net's Largest Vintage R/C Community

A long time ago I used to race Corally 1:10 scale pan cars. I don´t have any of them anymore. So I´ve been looking for one for my collection. A couple of weeks ago I found an add for a Corally SP10V locally. Pictures weren´t the best, it was sold as a project/scrap and the description only mentioned...

Here's my green 40th edition build so far. As soon as it was released I too decided to dye all the plastic green and black. Tried to make everything green and black, replaced silver colored parts and hardware with black where possible, installed black steering arms and ball cups from a DS, green tie...

Never thought I'd find one of these. This was my first RC10. Pretty sure mine was a late edinger simply due to when I purchased it but this Cadillac is close enough. The kit came as stripped down as could be- no electronics, no body, no wing, no driver. I had a stock car body on mine first, later we...

Frankentruck wrote: ↑Thu Feb 13, 2025 11:03 pm Amain now has the black one for $85. It's getting harder to resist getting one.

GrePo wrote: ↑Fri Feb 14, 2025 1:32 pm These all are babies toys compared to Rogue's and mine serious race proven machines ha ha haaaah

I mean if travel wasn't such a pain, we could do a build of the month RC race lol.

I just have to share this, as I am as giddy as a school-girl right now. There is a decent chance that I pick up an original '80s RC10 tomorrow morning!! :shock: At 50, I have never owned an original new B1, and I don't want to say bucket list, but pretty effing cool! :mrgreen: Something like this ha...

That's not a diamond in the rough, it's a diamond in the rust.

Chassis repair ongoing.
Please don't tell the wife.

SRB with Rc Channel upper and lower arm rear end, Scorpion shocks, Xtra speed chassis, and Dremel powered engineering...

Why the oven? Are you using pre-preg to reinforce the chassis? No pre-preg. Just to cold in the workshop to get the epoxy to harden properly. I put the oven on low temp for a couple of hours to speed up the process. This morning we have -11 degr C ( 12 F) outside temp. My workshop is only heated wh...

Finally finished the electronics on one of my blackfoot builds

I figured I would finally finish this CCP blackfoot build I call (Purple Rein) today. I've been stalling on the last step, which was the wiring, as I hate soldering 🙄 but I said today was the day, and I must say I like how it looks so far. Next, I'll polish up the body as it sat for a while, collect...

I finally started on this project, it was a b4 parts lot, missing rear shocks.

I picked up a set of 12mm rears when they were on eBay for not much money
Found some transmissions, but I need to disassemble it to see if if for the b4 or the b4.2/sc10

Motor options. I did not have Losi motors back in the day. Mostly, I had Trinity Monster Horsepower or B&R, as that is what the local hobby shops had in stock. 20250215_105307.jpg 20250215_105903.jpg This is what I had in there BITD. Need a pinion and a few misc screws to call it done (for now)....

GoMachV wrote: ↑Mon Feb 17, 2025 1:30 pm I'm gonna buy one, probably 2. But am I the only one that thinks it's a bit... Ironic?

my pin is cooler.