RC10Talk - The Net's Largest Vintage R/C Community

It's not pretty, but it fills a slot in my hit list. And now that I have it, that means another one cheaper and nicer should be popping up any moment. Maybe I should go wash my car too just to get the universe properly in motion. . PXL_20230520_201054823~2.jpg Every time I look at that motor, it br...

I got a truck in the mail.....

Not just any truck..... the 10Talk Raffle Truck!

Big thanks to @scr8p for building this up.... going to add a touch of clASS to my collection for sure!

Frankentruck wrote: ↑Mon May 22, 2023 4:47 pm What was the speed in these last runs?

64mph in 3.5 sec

Enough DU-BRO links to feed 2-3 Predator Lynx for a while.

1911Colt wrote: ↑Tue May 23, 2023 7:42 am Coincidentally, this was on TV this past weekend:

I'm about 10 minutes from the old jump site. I have considered seeing if I could launch a Bandit into the canyon

GoMachV wrote: ↑Wed May 24, 2023 2:16 am

1911Colt wrote: ↑Tue May 23, 2023 7:42 am Coincidentally, this was on TV this past weekend:

I'm about 10 minutes from the old jump site. I have considered seeing if I could launch a Bandit into the canyon

Just yes

You should swap the right side pinion around, tap it onto the diff tube, fit the large hole washer over pinion flange, and use a teflon diff tube bushing. rc10rhgear.JPG I believe you have misinterpreted the image :?: :D I have built quite a few of these and always the way shown. The right hand pin...

Not a great video and it finishes with a stripped gear , only a home 3d printed gear so no biggy. I shot some more after changing the gear but it's late so I'll upload it tomorrow .[youtube]https://youtu.be/C0H7obAWWoE[/youtube]

Thank you both for the input. I'll go for the Novak. Thing is I want the components to be fairly period correct. The only early generation Novak esc I have are the NESC 4 and NESC 1X. The wires are too short so have to resolder. I'll be using the 4 and as you see in the picture the wiring is identic...

All wired for 12volts, F26 Composite engine installed
Houston....we a have a go for main launch

Well I finally bit the bullet and cut out the body which is something I am really not good at but I think it turned out ok. Decided to replace the wing as well and ordered a pink one from JC Racing that will look a lot closer to the box art original than the orangie pinkie thing I had going on befor...

So last weekend I went to the Jconcepts INS race at Adrenaline R/C Raceway in Winchester, VA. I raced this in the 17.5 Independent class. The car worked pretty well. I tried some different setups.... mainly tire and spring changes, but by the time the mains came around on Sunday I was back to where ...

Nearly done with the t3 I finally can make nice nonwrinkled pieces IMG_2267.jpeg No wrinkles in the bag or release film IMG_2269.jpeg Nice smooth finish inside I am going to do a cosmetic layer to clean up the rear bulkhead. I may do another external layer if the diamond plate takes to long to fix T...

Today.