RC10Talk - The Net's Largest Vintage R/C Community

The 917K required some colors... I thought about red/white, green purple and blue orange, and that's the last one I chose...

Normally, the 917K should be ready for Belley

A classical use of the simple characteristic "PLA and PETG don't stick together" T7G7skJAPx0 Bambu Lab PLA Matte white as Support interface (3 layers, 0 gap in Z) Sunlu PETG transparent with Generic PETG profile Worked like a charm, no oozing, no cross material pollution. Beside the suppor...

Another thing I did within the week-end was to print a TPU part. My daughter's car exhaust had an issue : the silent block (rubber) was broken, and the main exhaust tube detached itself from the collector. I had to find a temporary solution until we get the replacement parts (silent block and conne...

Not exactly today, that was more during the long week-end we had here in France, but met again @TravelinTravis and @Trass in Belley for few days of RC vintage fun...

The Makera Carvera Air arrived yesterday, about 3 months after the order... https://i.imgur.com/7JNM4nm.jpeg Had no time to unbox it yesterday, I did it today... https://i.imgur.com/8yvCtKB.jpeg After removing the protecting plastic, it looks like this... https://i.imgur.com/AkjEd3w.jpeg And a bit l...

A bit later (not looked at the time, but more than one hour later), the detail operation is done and we get a prompt to change tool again... https://i.imgur.com/dJezuS5.jpeg Here is the detail before the cut operation https://i.imgur.com/UMRxvKo.jpeg I changed tool, and it restarted to finish the pr...

After the first test, I wanted to do my first special part... But before, as you have number for tools when you prepare the work, I went to makerworld and found a perfect storage for the tools to be used in a work... https://i.imgur.com/JDIP7Ir.jpeg (https://makerworld.com/en/models/1389826-carvera-...