RC10Talk - The Net's Largest Vintage R/C Community

The current chassis is almost perfect, I only ran into 3 minor issues. The arms that screw into the ball stud mounts on the rear bulkhead are about half mm too high, the strengthening ribs at the front kickup need a hair more clearance for the bellcranks, and the hex for the bell crank shafts are a ...

Junior stuff

It’s amazing what you can accomplish when you give up sleep

That'll do

Will add the file to the chassis listings. You will need 3mm screws and might need to drill the posts a little.

Sacrilege!

Looks like the site may have to change it's name

MINIJRX2Talk.com.cn

Looking a little more proper now with the correct color H arm. Test fit of the “mini” bumper works well but I didn’t space the bellcrank posts yet. Working on the 2038 hubs today.

To those that can design 3D Printed parts - Can someone design a mini hex adapter so we can use Mini B and Mini T 2.0 rear rims? It would need to be wider where the pin is then standard mini hex size (8mm?) If you currently change the pin this can be done with a stock Mini B/T hex. I'd like to see ...

Losi's have been my thing for far far too long... I still curse Losi for releasing these as now it is ALL I can think about :lol: As for the mini T springs being longer, that might be good, the stock springs look far too short if you have to have the collar dang near at the cart for preload.. Adding...

Here’s my mini JRX2 with mods from Jeff and various electronics & motor.
- limestang

Well dangit, everything is going just swell and then you turn a corner and run smack dab into a roadblock. I have taken down the chassis for the moment as when I had everything together for todays photos I was unable to turn the bellcranks. Turns out the thicker Junior shocktower with a cap head scr...

That is awesome Jeff! I have been up way late again working on hubs this time. I am a bil leary on the lack of meat where the ball stud goes I may have to reduce the number of holes... but I dun wanna :p Also I have no drive shafts or rear wheel bearings yet so cant actually test how the bearings fi...

I left the carrier as close to original as I could and I agree with all those holes the chances of breakage are high but it just looks “right” with em. On the clips, I left them open but not really snappable. I wanted the look but wasn’t concerned about the functionality since we don’t have the corr...

I made them clippable because I needed them to be spacers so it made sense :) Well I guess everything I need for the Junior that I can make is made, I guess I will look into making lxt parts out of madness... any chance I could buy a custom set of shocktowers for a lxt? Lol Edit: I just put the hubs...

Hmm...