RC10Talk - The Net's Largest Vintage R/C Community

these are available: https://www.shapeways.com/product/EEYTAZZ6Y/losi-jrx2-and-jrxt-lower-shock-mount?optionId=65007989&li=marketplace https://www.shapeways.com/product/DULYY7WLF/team-losi-jrx-2-a-5000-rear-lower-shock-mount?optionId=240524179&li=marketplace I know I saw ones that were close...

The last part for my JRXPro build.

I had noticed in the replacement parts that the cartridges come unassembled.

Hmmm....


I love 3d printers...

Working my way up to modeling the junior chassis....

https://i.postimg.cc/TYvNPFHw/E6-ED768-B-ED3-C-4626-AE08-B01540705-EAD.jpg I’ve been comparing the mini Jrx2 to the MiniT2.0 and noticed they use the same diameter springs. The longer rear springs on the mini t can be used to replace the too short rear springs on the Jrx2. You could also get both m...

Mine arrived on Monday. I've had a chance to run it a couple times, and I'm having a blast with it in my driveway.

Working on the molded chassis at the moment but thought I would toss up the WIP body mounts, I have not modded anything so it is unlikely a screw is going to fit in the adjustable part of the front one... but that is what drill bits are for! Have fun lol https://cults3d.com/en/3d-model/game/losi-tru...

The current chassis is almost perfect, I only ran into 3 minor issues. The arms that screw into the ball stud mounts on the rear bulkhead are about half mm too high, the strengthening ribs at the front kickup need a hair more clearance for the bellcranks, and the hex for the bell crank shafts are a ...

It’s amazing what you can accomplish when you give up sleep

That'll do

Will add the file to the chassis listings. You will need 3mm screws and might need to drill the posts a little.

Looking a little more proper now with the correct color H arm. Test fit of the “mini” bumper works well but I didn’t space the bellcrank posts yet. Working on the 2038 hubs today.

Well dangit, everything is going just swell and then you turn a corner and run smack dab into a roadblock. I have taken down the chassis for the moment as when I had everything together for todays photos I was unable to turn the bellcranks. Turns out the thicker Junior shocktower with a cap head scr...

This is what I have come up with so far, I am doing some test prints to make sure everything is where it should be. It is not 100% accurate but it allows the outdrives to push through the case without universal joint disassembly. This should allow it to work with whatever they come up with in the fu...

That is an amazing build! I love the two cars together. Everything looks perfect. Could both be box art cars.

Just want to say, your Jrx2 has turned out a thing of beauty