RC10Talk - The Net's Largest Vintage R/C Community

I found Pukka Parts on Facebook, with this SRB conversion kit. It's more or less an MIP style setup.

Really nicely done stuff, a combo of frp and printed parts.

Thank you for the compliment

5mm charge adapter, cut the unneeded plug off and you've got solder free bullet leads. $5 to $10 depending on where you buy them.

The Reader's Digest version is that AE had all they could handle making RC10s, so they didn't have the capacity to also do a 4WD racer. Their team drivers had to run RC10s in 2WD obviously, but were free to run any 4WD. A lot of them chose Yokomo. Yokomo was in basically the same situation only reve...

The Reader's Digest version is that AE had all they could handle making RC10s, so they didn't have the capacity to also do a 4WD racer. Their team drivers had to run RC10s in 2WD obviously, but were free to run any 4WD. A lot of them chose Yokomo. Yokomo was in basically the same situation only rev...

Got the decals fine cut and ready to go. Took longer than I had anticipated.

This is the November 1994 catalog & price list from Savon Hobbies which was located in Miami Florida.


130 Pages

1988 World Engines Catalog - The pages have been color corrected to look like new since they were yellowed with age.


58 Pages

Truck is back to tribute again. Still modern esc and Rx tho.

Swapped parts out and restored the OG truck back to running shelf queen. The new kit build begins...

Team Associated two page ad from 1997 featuring: RC10T2 - 2wd 1/10th scale electric stadium truck - Released in 1995 RC10B2 - 2wd 1/10th scale electric buggy - Released in 1995 RC10DS - 2wd 1/10th scale electric pavement - Released in 1996 RC10GT - 2wd 1/10th scale gas stadium truck - Released in 19...

1990 JR Catalog


22 Pages

Chased the 4014 for a little ways today. It was a couple hours from home and my timing was bad, almost missed it. Literally parked as it was coming around for the bend. Ended up stopping at the bend for a quick lube job

In 1991 Traxxas released the next evolution of their racing truck, the Blue Eagle LS. The new LS (which stood for Long Suspension) carried over a number of key parts from the previous Blue Eagle, such as the transmission, front and rear bulkheads, graphite shock towers, shocks, bellcrank steering an...

Waiting to remove the masking a bit longer. I do have Tamiya Polycarbonate Paint remover, in case I have to clean up any bleed. https://i.imgur.com/yDCQiTI.jpg https://i.imgur.com/w2aNpBC.jpg I cannot figure out how to cut this wing to make it look like the box. Going to look at the vintage manual t...