RC10Talk - The Net's Largest Vintage R/C Community

I wanted to share some pics of my Halsey edition, nice and low and 4WD. I wanted to get the body really and also show off the the Factory Works Ten 4.1 kit, I really like the mechanical look of the belt and pulley sticking through the body...kind of a supercharger sticking through the hood look. MCI...

Arundel c200 and some Jay Halsey left over colors! Sprayed by little Trey Waiting on new body mounts.

https://youtu.be/i2LdtoK9Ldg guys check out my rc10cc hot trick mip irs buggy with factory works parts!

Needed to cut the Halsey-Thompson Reedy sticker in two as there’s curves in all directions on the roof.

I was so excited to see this I had to create an account. Purely speculation, but when watching the RC10GT video I noticed the shelf over Curtis’ shoulder has what appears to be a ReRe Team Car, ReRe 10T and then below sits a Worlds car and a body less Stealth car (looks to me a 91). Hopefully it mea...

Family photo! On the left are NESC 1X, 1, and 4 with 3 screw cases and 4 wire leads. On the right NESC 2 and 4 with taped closed cases and 3 wire leads.
.

romulus22 wrote: ↑Fri Jan 10, 2025 7:57 am I dig that paint job, very retro ish.

Thanks.

My buddies call me Candy Corn.

Dadio wrote: ↑Sun Jan 19, 2025 6:33 am Just another 9 votes and it's all mine !

Maybe a water pipe will burst and, when the counting resumes, you are mysteriously leading by 9 votes...

Playing with a nylon screw kit I picked up off Amazon. Added some vertical stabilizers.

Oooooh! It gets even better!
I found T1/T4 instructions online.

Three power wires and the reciever wires centered!
So a third variant?

Some Hot Trick (style) stuff

Ignore the clear bulkhead, I keep stuff like that around for mock up

Back in 1990 I was new to r/c and picked up an AE 6010 short arm kit from my LHS. In no time I swiss cheesed the chassis and started dumping money into it. After running off-road for a bit I decided to convert it to dirt oval with a McAllister lowering kit, MIP SP-1, Andy's arms, graphite chassis, t...

The Jammin Jay Halsey edition is done! The final bits came in the mail yesterday. The Yokomo wing buttons. I did use transparent double sided tape on the wing for a cleaner look. This was a good build. Lots of metal work and small details to address. Some appeared under the build when you really stu...

Just sharing HPI wide chassis rc10l.
HPI wide chassis, upper & lower pod, rear brace, front arm brace, shock, and hubs.

Had the kit when I still lived in Maine, but didn't build it until now because I got cancer. Jesus cured me, so now I don't have cancer anymore, but a renewed motivation to complete all the kits and parts cars that were sitting in my storage. I never had a real desire to get an Ultima until I saw Sh...