RC10Talk - The Net's Largest Vintage R/C Community

the new Tamiya Pajero is just terrible... so I did this The title to this post is just terrible... so I did this 🤮 :P :lol: Cool little Pajero... needs decals though. :P I remember that episode as being a must watch after seeing the "next week, on Punky Brewster" teaser. Waiting the whole...

In 1994 Traxxas would unveil their most advanced racing truck, the SRT. The Stadium Race Truck would replace nearly every component of the previous LSII in the same manner as the TRX-3 did for the TRX-1. Starting with a .125in shorter wheelbase flat plate fiberglass chassis, a new bolt-on front bulk...

Sorry I am late to the "Trans Am" discussion.

Sports Car Club of America (SCCA) owns the name Trans Am. Pontiac licensed it from them. It is rumored that there were a lot of years in which the royalty check from Pontiac was the biggest item on the SCCA's books.

Ok so is the body that comes with the kit a Trans Am like AE says on their site or is it a Ford Mustang like the Fakebook Mafia swears it is? Yes. It's AE's rendition of the Mustang Tommy Kendall drove in the SCCA Trans Am series. https://gotransam.com/images/content/full/Tom%20Kendall%201997.jpg T...

Personally, I like the Windex and hair dryer method. It works really good for weird angles and body lines.

I use a small (breath spray size) pump sprayer that I got somewhere.

The decal squeegee was delayed in delivery, won't be here until tomorrow now. Hoping to finish Sunday. Some guys swear by the soapy water technique with decals. Kinda gives you some time to float them around and get the placement right, then squeegee them down/run the air and liquid out from undern...

Helpful advice and nice experiment with the coin lol...big improvement!

TIL Pro-Line's first stab at progressive shocks happened back in 1984:

Hello, While building up my YZ-10 ReRe I wanted a nicer way to ensure the wires from the ESC to the motor don't get in the way of the belt. I threw together a 3d model and printed this mount to route the wires cleanly. Still a bit of a work in progress. If people would like the unfinished stl I can ...

The fitment of the factory battery tray was right against the servo posts and the height of it would interfere with the connector cables for my hardcase lipo battery packs. I redesigned a tray that has a lower height to avoid the battery pack cables, put a relief in it to allow plenty for clearance ...

Made this mostly for aesthetics. The Jconcepts brace is backordered everywhere so I modeled this up for fun. I have weight it but it is about the same weight as the factory brace but a bit stiffer when printing it with carbon infused filament. Work in progress, I will print one up that removes the p...

https://www.facebook.com/share/r/KYRrkhWoQ8NRryC7/?mibextid=WC7FNe

- limestang

Advertising nearly all the vehicles from their product range in 1995 Traxxas showcased buggy's, trucks, nitro's, a couple boats, and a glimpse at a very rare 1/5 on-road sedan: Rustler: 1/10 2wd electric stadium truck, debuted in 1994. Stampede: Released in 1994 as a platform shared 1/10 2wd electri...

Stunning day at the Remarkables Queenstown Nz taken from the bar at the top it’s a panoramic so tap on it for a better look
Sorry qualities a bit crap so don’t bother

my Tenth Tech Streetwise Just arrived today. Always wanted a Predator but after years of looking they are just not in my price range. So an economy version it is!