That is one nice car Bill, I have been back several times for a look, right down to the wing and shocks. Thanks for posting , and what are your plans for it?
got bored today, snapped some pics of a couple projects that are pretty much done.
first is a rpm ultra-molded chassis conversion for the rc10.
full-on rpm besides the trans, i keep forgetting to order a rpm trans for it as well as a b2 body that...
Last post
Thanks Hoopty... I'll pass by one of the LHS here and check out their Trinity wheels.
Found some good stuff digging in some old boxes at a LHS. Thought I would show some of some. :D
The rims are front regular width and the rear are 2.0 RC10.
I am working the next project out.
Last post
I have an identical set of rear associated rear wheels like thoes, only mine came white.
I received this from the mailman today. I have a problem with the bell crank thou. I need the one for an RC10 either stock or aftermarket part will work for me. Used ok. And a rear shock tower to go with that. And also, I'll be needding a balack...
Last post
Sold that on ebay yesterday. :D
Just the chassis and some other stuff. Here she is now.
well after getting started on my wife's rc10 runner and racer builds and my son's rc10 project i figured i would get started on one for myself. this car is being built as a tribute of the rc10 i raced bitd. some of the things i am doing to this one...
Last post
Pink and neon colors mixed together, Isnt that what the 80's were all about. :D
Thought i would share some pics of my rc10.
I actually got given this for free with a joblot of schumacher stuff.
Been told this has the rpm worlds conversion? Any other info you guys can supply me will be greatly recieved.
Last post
Killer score. I still have a lightly used RPM kit that I need to put on a buggy one of these days. Still looking for the right chassis....
After searching for a while I finally scored the much sought-after RPM cover for my LRM slipper set-up, and I can't get anything on the forward-most screw. The old scans say to use a nylon 4-40 nut, and the smallest one I could find doesn't fit....
Last post
I use a small peice of rubber tube (peice of wire with the strands removed) its just a tight push-on fit but works OK.... think I might try the ball joint trick as that looks like it could be more secure?
I believe this is a belt drive conversion for a Yok 834B but all I only know is that it resembles parts I have seen on this forum before. The drive gears (sprockets) both have 10 teeth and the belt is approximately the right length to replace a...
Last post
That's really nice! The only car I've seen with an aftermarket belt drive conversion. How do you adjust tension?
Good question, because it is a direct replacement for the Yok chain drive pieces there is no way to change belt tension that I'm aware...
A friend of mine gave me this for Christmas which looks to be an RPM conversion. Sadly the top deck looks to be cut and is broken. I'll probably dye the blue nylon black and try to get a new top deck made. I assume white RPM arms and stuff are near...
Last post
When I first saw the car I thought composite craft. It also looks like it's missing a few bits so I may do a modernized car similar to Jakes NIX91.