i'm running rpm arms but they appear to be the same length as stock.
turns out i did ruin a few of the rpm cups, threaded right through them when i was adjusting the rods.
i have a set of white jconcepts on order now.
titanium turnbuckles / tie rods
-
- Approved Member
- Posts: 1679
- Joined: Sun Aug 13, 2006 10:54 pm
- Location: Houston Texas
- Has thanked: 2 times
- Been thanked: 4 times
Re: titanium turnbuckles / tie rods
RPM arms make no difference. Are you sure you didn't get the GT2 set? Sounds obvious, but if you just look at the label quickly it would be an easy mistake to make. Maybe they were mis-labeled???
Re: titanium turnbuckles / tie rods
i held them up to the stockers and they are the same length.justinspeed79 wrote:RPM arms make no difference. Are you sure you didn't get the GT2 set? Sounds obvious, but if you just look at the label quickly it would be an easy mistake to make. Maybe they were mis-labeled???
Re: titanium turnbuckles / tie rods
Anyone know if the original one from technacraft can still be had?
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 0 Replies
- 320 Views
-
Last post by tecnica2001
-
- 5 Replies
- 591 Views
-
Last post by littleVETTE
-
- 4 Replies
- 175 Views
-
Last post by radioactivity
-
- 8 Replies
- 922 Views
-
Last post by Sir
-
- 1 Replies
- 427 Views
-
Last post by scr8p
-
- 12 Replies
- 2253 Views
-
Last post by FordPSD
-
- 5 Replies
- 543 Views
-
Last post by juicedcoupe
-
- 0 Replies
- 507 Views
-
Last post by scr8p
Who is online
Users browsing this forum: No registered users and 4 guests