askbob wrote:Maybe a rookie question, but did RPM make the team/widetrack front arms in white? Not the RPM worlds conversion type, standard wide track.
Rears are much easier to find than fronts. But they are out there.
I am trying to find a set of rear Andy's arms in white but that full set of RPM arms would work. If you don't move on them Bob, please pass me the info.
Does any one still make white white front arms for the Team/Worlds cars? I recall seeing some that are still made on the forum but cant find the thread now. Thanks
Last post
Thanks you. You have a stunning looking car there scr8p. Its a shame there only the wider arms.
I finally managed to get hold of a set of white front a-arms for my Worlds Re-Re.
However, the a-arms bind/rub with the worlds re-re shock rod end. The space for the bottom of the shocks is marginally larger on black a-arms (1mm bigger?)
What...
Last post
Where did you find white arms? I would love to get a set.
Installed a set of RPM B4 arms on my B4.1. Haven't had a chance to run them, but def beefy compared to the stock front arms!
Before
After
Last post
The rpm arms were great on a loose loamy track. No problems whatsoever. On a hard packed Clay I just didn't like the way the truck drove and the rtr arms were even worse. It was a shame cuase the truck was unstoppable with the FT arms until they...
While rebuilding my original Worlds, I decided to swap the arms on the front and back for RPM arms. Unfortunately the ball ends of the shock do not fit in the arm. The ball is too deep for the arm.
Can I use any ball end on the shock that'll fit?
Last post
Great thanks.
I actually found those while looking and almost hit the buy button but hesitated.
i was digging through my big box of rc10 parts (some old, some aquired with resto cars). i have a odd set of white rpm arms and today was when i wondered.... could those be worlds arms ??? they are!!!!! yipeee!!!!
i will eventually stumble on a rpm...
Last post
i was watching that rear. i will eventually find a rpm rear on a junker i hope lol
The later AE arms for the 10T, GT and T2 have the spacer for adjusting the wheelbase. The early AE white arms and the RPM arms dont. My question is lined up next to each other is Does the RPM arms line up with the short or long position or are they...