New 6010 Box Art Car Build
- mikedealer
- Approved Member
- Posts: 1778
- Joined: Fri May 18, 2007 12:25 am
- Been thanked: 3 times
New 6010 Box Art Car Build
Well ive been buying parts on ebay when i find them cheap, or buying them at local hobby shops if i find a good deal... been going through a couple boxes of NIP parts, and dug out enough (almost enough lol) to build a box art car.. Figure everyone should own at least 1 mint one.. Got a front and rear end kit, kimbrough mounts, fiberglass battery brace and tranny brace (on the way that is lol), and new/never run novak reciever with 3 female prongs, and novak reciever with male prongs
So as soon as i can find a:
-New Chasssis
-New Noseplate
-New Front and Rear Shocks
-6 Gear Tranny top shaft
-Suitable Speed Controller (looking for a novak 1/2/3/4)
Im going to throw it together
So as soon as i can find a:
-New Chasssis
-New Noseplate
-New Front and Rear Shocks
-6 Gear Tranny top shaft
-Suitable Speed Controller (looking for a novak 1/2/3/4)
Im going to throw it together
- Attachments
-
- P2040089.jpg (104.91 KiB) Viewed 1191 times
- P2040089.jpg (104.91 KiB) Viewed 1191 times
-
- P2040090.jpg (98.03 KiB) Viewed 1191 times
- P2040090.jpg (98.03 KiB) Viewed 1191 times
-
- P2040091.jpg (116.16 KiB) Viewed 1190 times
- P2040091.jpg (116.16 KiB) Viewed 1190 times
-
- P2040092.jpg (128.22 KiB) Viewed 1188 times
- P2040092.jpg (128.22 KiB) Viewed 1188 times
-
- P2040093.jpg (142.06 KiB) Viewed 1186 times
- P2040093.jpg (142.06 KiB) Viewed 1186 times
-
- P2040094.jpg (111.24 KiB) Viewed 1183 times
- P2040094.jpg (111.24 KiB) Viewed 1183 times
-
- P2040095.jpg (123.36 KiB) Viewed 1182 times
- P2040095.jpg (123.36 KiB) Viewed 1182 times
-
- P2040096.jpg (151.21 KiB) Viewed 1181 times
- P2040096.jpg (151.21 KiB) Viewed 1181 times
- templeofspeed
- Approved Member
- Posts: 2102
- Joined: Tue Aug 01, 2006 10:02 pm
- Location: Central Ohio
- Has thanked: 3 times
- Been thanked: 32 times
Re: New 6010 Box Art Car Build
Cadillac motor (although a super early one without brush hood heatsinks!), Stealth motorplate...
c'mon Mike, you can do better than that!
Nice start though, I'll look to see if I've got a new topshaft for you.


Nice start though, I'll look to see if I've got a new topshaft for you.

- mikedealer
- Approved Member
- Posts: 1778
- Joined: Fri May 18, 2007 12:25 am
- Been thanked: 3 times
Re: New 6010 Box Art Car Build
ya i know lol... i actually do have a better motor but label is scratched a bit more.
- templeofspeed
- Approved Member
- Posts: 2102
- Joined: Tue Aug 01, 2006 10:02 pm
- Location: Central Ohio
- Has thanked: 3 times
- Been thanked: 32 times
- mikedealer
- Approved Member
- Posts: 1778
- Joined: Fri May 18, 2007 12:25 am
- Been thanked: 3 times
Re: New 6010 Box Art Car Build
worked fine, had to re-wire but i had a novak plug from a destroyed servo.
- templeofspeed
- Approved Member
- Posts: 2102
- Joined: Tue Aug 01, 2006 10:02 pm
- Location: Central Ohio
- Has thanked: 3 times
- Been thanked: 32 times
Re: New 6010 Box Art Car Build
Futaba G plug... Red is for Rx power (like from an external Rx pack or off the MSC), BTW.
There is a guy on ebay selling 12" G plug leads with black plugs:
http://cgi.ebay.com/Heavy-Duty-Servo-Lead-wire-12-in-Futaba-G-connector_W0QQitemZ170141710356
Just in case you wanted to do it right...


http://cgi.ebay.com/Heavy-Duty-Servo-Lead-wire-12-in-Futaba-G-connector_W0QQitemZ170141710356
Just in case you wanted to do it right...

- mikedealer
- Approved Member
- Posts: 1778
- Joined: Fri May 18, 2007 12:25 am
- Been thanked: 3 times
Re: New 6010 Box Art Car Build
this plug is actually orange? and it was on another novak servo i had, its possible it was re-wired at some point though.. thanks for heads up
- templeofspeed
- Approved Member
- Posts: 2102
- Joined: Tue Aug 01, 2006 10:02 pm
- Location: Central Ohio
- Has thanked: 3 times
- Been thanked: 32 times
Re: New 6010 Box Art Car Build
Orange... red... Ok, not black. I guess I do have some plugs that are more red than orange, but the only servo I have with a red/orange plug is a super old S16 that was hacked quite visibly. That doesn't mean there were no servos with orange/red plugs, but I have a dozen old Futaba servos (and five Novaks, both Bantam Midget and NES1A), and all the un hacked ones are black. I'm just going by the majority. No offense intended I'm sure you realise. All the four cell RX packs I have are red/orange as are the old FP-2TF radio TX packs.


- shodog
- Approved Member
- Posts: 3813
- Joined: Thu Oct 05, 2006 3:09 pm
- Location: Washington
- Has thanked: 3 times
- Been thanked: 91 times
- templeofspeed
- Approved Member
- Posts: 2102
- Joined: Tue Aug 01, 2006 10:02 pm
- Location: Central Ohio
- Has thanked: 3 times
- Been thanked: 32 times
Re: New 6010 Box Art Car Build
shodog wrote:How can you tell it's a stealth motor plate?
The additional hole for the Stealth trans.
After a while you can pick 'em out in a blurry cell phone pic on ebay.
- Attachments
-
- stealth.JPG (42.75 KiB) Viewed 1108 times
- stealth.JPG (42.75 KiB) Viewed 1108 times
- mikedealer
- Approved Member
- Posts: 1778
- Joined: Fri May 18, 2007 12:25 am
- Been thanked: 3 times
Re: New 6010 Box Art Car Build
so this would be more period correct, oh well lol.. i did know that lol.
http://cgi.ebay.com/NEW-Associated-RC10-MOTOR-MOUNT-84-Gold-FREE-SHIP_W0QQitemZ300196562746QQihZ020QQcategoryZ34063QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
http://cgi.ebay.com/NEW-Associated-RC10-MOTOR-MOUNT-84-Gold-FREE-SHIP_W0QQitemZ300196562746QQihZ020QQcategoryZ34063QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
- scr8p
- Administrator
- Posts: 16751
- Joined: Tue Feb 07, 2006 9:46 pm
- Location: Northampton, PA
- Has thanked: 33 times
- Been thanked: 1216 times
Re: New 6010 Box Art Car Build
ya, that's the one you'd want.mikedealer wrote:so this would be more period correct, oh well lol.. i did know that lol.
http://cgi.ebay.com/NEW-Associated-RC10-MOTOR-MOUNT-84-Gold-FREE-SHIP_W0QQitemZ300196562746QQihZ020QQcategoryZ34063QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

- templeofspeed
- Approved Member
- Posts: 2102
- Joined: Tue Aug 01, 2006 10:02 pm
- Location: Central Ohio
- Has thanked: 3 times
- Been thanked: 32 times
- mikedealer
- Approved Member
- Posts: 1778
- Joined: Fri May 18, 2007 12:25 am
- Been thanked: 3 times
Re: New 6010 Box Art Car Build
i actually have a few mint motor plates for 6 gear, this one was just NIP. even on the most beaten to death cars.. motor plates are usually in great shape.
- scr8p
- Administrator
- Posts: 16751
- Joined: Tue Feb 07, 2006 9:46 pm
- Location: Northampton, PA
- Has thanked: 33 times
- Been thanked: 1216 times
Re: New 6010 Box Art Car Build
ohhh....................... i'd have to disagree with you on that one.mikedealer wrote:even on the most beaten to death cars.. motor plates are usually in great shape.

Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 2 Replies
- 1387 Views
-
Last post by lmw94002
-
- 7 Replies
- 1354 Views
-
Last post by Twin Detonator
-
- 68 Replies
- 13114 Views
-
Last post by RC10resto
-
- 17 Replies
- 2734 Views
-
Last post by Charlie don't surf
-
- 5 Replies
- 2155 Views
-
Last post by FasterLouder
-
- 3 Replies
- 1371 Views
-
Last post by lotus15racer
-
- 11 Replies
- 1972 Views
-
Last post by SFC K
-
- 17 Replies
- 2598 Views
-
Last post by asashaw
Who is online
Users browsing this forum: Amazon [Bot],
curl [Bot],
skrichte and 7 guests