Jrx2 modern wheel adaption

Post by **scoobyrs25** » Mon Jun 06, 2016 11:36 pm

Any straight forward solution to running modern 12mm hexes on my Jrx2? I figured I'd just upgrade the front of the car with RB6 front axles/spindles. I was hoping there was an available hex for the rear.
Thanks,
Kevin

Post by **clm** » Tue Jun 07, 2016 1:17 am

Modern wheels... If I remember correctly the easiest way is to use b4 wheels with a spacer on the stock axle on front.

Post by **RCveteran** » Tue Jun 07, 2016 7:53 am

B4 wheels direct fit front but rear requires small .125" spacer usually to avoid rubbing or custom works spacer. Im sure you could drill any standard hex to fit rear axle and pin and experiment with wheel offset from there. There are other ideas with regard to changing axles, Google jrx2 modern wheel.

Post by **LosiXXkid** » Tue Mar 07, 2017 9:20 am

There's always this option to run standard XX or XXX wheels....

http://www.rc10talk.com/viewtopic.php?f=27&t=36070&start=15

RC10Talk - The Net's Largest Vintage R/C Community