Bluebird Servo's w/Helical Gears, no low profile models.
-
guitronics
- Approved Member
- Posts: 63
- Joined: Sat Apr 30, 2016 2:54 pm
- Location: Eustis,Florida
- Has thanked: 297 times
- Been thanked: 5 times
Bluebird Servo's w/Helical Gears, no low profile models.
I just found out that Bluebird Servo has a line of "Helical Gear" models. The only problem is" they don't have any of those in a "low profile" configuration. Would there be enough room in an RC10 for a regular sized servo?
-
juicedcoupe
- Super Member
- Posts: 3445
- Joined: Sun Aug 16, 2020 4:05 pm
- Location: Pascagoula, MS
- Has thanked: 265 times
- Been thanked: 2033 times
Re: Bluebird Servo's w/Helical Gears, no low profile models.
The linkage angles aren't as good but its doable.
Depending on the design of the servo and the servo horn, it may be possible to mount the linkage on the inside.
Depending on the design of the servo and the servo horn, it may be possible to mount the linkage on the inside.
Always looking for new and interesting ways to waste money.
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 8 Replies
- 1243 Views
-
Last post by Lee_123
-
- 3 Replies
- 911 Views
-
Last post by juicedcoupe
-
- 6 Replies
- 964 Views
-
Last post by flipwils11
-
- 26 Replies
- 5326 Views
-
Last post by bobks
-
- 59 Replies
- 4587 Views
-
Last post by Mindwarp
-
- 5 Replies
- 990 Views
-
Last post by Brat
-
- 3 Replies
- 645 Views
-
Last post by GoMachV
-
- 4 Replies
- 850 Views
-
Last post by SmallScaleSmitty
Who is online
Users browsing this forum: No registered users and 3 guests