LRM slipper upgrade parts

[JRxJoe]

Hi everyone,

Well, as the builds progress for the Pro and Pro SE, I am still locating parts. My Pro SE is complete with a completely restored slipper and hydra drive, but for my Pro I am looking to add a slipper that has a little more capacity than the original. Unless I can find a complete original setup.

I read through this article: http://vintagelosi.com/SingleToDual.html

I do need the longer output shaft A-3120, as well as the two slipper backing plates A-3121 (the earlier longer style) and A-3132.

XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX

I did notice the A&L Powerclutch kit is available, but seems like it is very limited in its ability to support more modern brushless motors.

https://www.ebay.com/itm/304102995019

It looks like a nice complete setup for a shelf queen though.

thx

Joe T.

[jwscab]

The top shaft is a double d isn't it? I think you can run a b4 style slipper with the appropriate spacers.

[JRxJoe]

Well, I ordered all the necessary parts already from all over the web and now i just need the A-3120 shaft. After that I should be ready to assemble. I ended up using an 86T Losi 22 Kevlar spur since the article says anything from a 22 will work. at $7 for Kevlar impregnated plastic, it was worth it vs the crazy prices I saw on eBay for a vintage spur.