I got a result and managed to pick up a set of nip 1001 servo gears. I have 2 servos out of action because of gears, so now have another one up and running.
Happy days.
Finishing up a partially built 12L4 I snagged on ebay and I planned on putting in a Futaba S3002 metal gear servo. The problem is, the metal spline has really fine threads and a really short screw. The screw is long enough to mount a horn but not a...
Last post
that was a great deal on that L4, I almost bid on it but I want a link car so I can run Lipo. Are you going to come out to Thunder to run it?
Yea, it was thanks. The seller was a little careless and didn't bother to bag the rest of the small...
What's up guys. Been while since I posted. Got back to working on my 10Ts and need some advice on a few ideas. Can anyone offer a good metal gear servo to put in the trucks? And looking to change the gear ratio in the tranny (at least that's what I...
I finished steering servo shopping for RC10 runner. There are a load of threads on this board on ins and outs of Lipo and Brushless modern amenities for the vintage runners. But not a whole lot on servos frankly. These days you can get metal gears...
Last post
I havent bought a new servo in, 15~20 years (outside of ones in cars I have bought used). I still have my 3 Airtronics 94258/94358 analog monsters. Super quick and very powerful, I run them in my JRX, RC10 and Short Course truck. Recently I went to...
I’m restoring/building a losi xxt. Light runner....maybe...as I am new to this Modern electronics, i was wondering what would be recommended for the steering servo. When looking at a main, looks like a bunch of different sizes, torque. It’s been 20...
Last post
Hitec 645mg will do u good in your application. For more demanding running stick with savox 1257 or 1258. Savox 1251 low profile if space is an issue.
I have a rtr t4 and i just broke the servo (at the track).. the built in servo saver seemed loose but is that not enough?? Are people runing mini servo savers on the servo too?? any help would be great...
Last post
yeah, just upgrade the servo and not have to worry about it again. That S3305 is over twice the torque of the 1504 that comes in the T4 rtr with similar transit speed. I have one that's been in a spec slash for well over two years now, it usually...
