are any of you running them on your racers? i run my rc10 on astro and in tight 180's off a fast corner the car will pick up in the inside front wheel as its transferring to much weight to the outer rear wheel.
im using rpm worlds arms and was...
Last post
i have some coming. i will post up as soon as i have them on.
hey all i know i could easily make sway bars for my gt but i wanted to know if any mfg ever made sets for the older black tub
thanks
Last post
Here's mine. Endlinks are from the associated t4 rear swaybar kit. Lower mounts are just a long ballstud with a spacer between the aluminum ends. Bulkhead is all stock 10GT. I took the kit swaybars and spread them out a bit and just used music wire...
Anyone do anything similar or better. I'm always looking to improve. This car is a runner, and it is beginning to hold its own with the B4's on the clay.
Last post
That's a very nice setup. I'll have to look into doing something like that with the RPM arms. Thanks for the pics.
Quoted from DMAT, on an Ebay RC10 that Charlie Don't Surf noticed. It intrigued me, so here it is before I pull it apart to clean it. I'll take more pics in better light later.
RC10A1.jpg
Sway bar action
RC10A2.jpg
RC10A3.jpg
More sway bar...
Last post
I must agree it's too bad that chassis is drilled!
did this when i saw a bumper for a rock crawler jeep its made out of a peice of coat hanger and i make 1 for the back.. just cut about foot of coat hanger put the ends in the wing holders (i dont run wings). i got tired of wreckin my world car shock...