Your runner cleaning techniques w/o disassembling

[klavy69]

So can anyone say if this is decent for an airbrush? Sorry for the bump, but I think it got lost in the mix and I'd really like to know without starting a new thread or sending a pm. It says it will, but is it any good?

if that is all you are going to use it for is airbrushing your car bodies and the occasional bicycle tire it should work just fine. If you put it to a rigorous pace of using it hard on a daily basis...not so much. Harbor Freight pushes for you to buy their extended waranty and most of the time anywhere else I pass it by... but selfbranded HF air tools/compressors just don't seem to last if you use them hard.
Todd

[klavy69]

Who here has ever put R/C parts in the dishwasher before? *Raises hand*

my wife is the dishwasher. she won't clean my cars.

scr8p brings up a valid 'other side of the coin' point...she wasn't too happy when I put my stuff in the dishwasher but she got over it
Todd

[allaircooled]

Who here has ever put R/C parts in the dishwasher before? *Raises hand*

I've put full scale auto parts in the dish washer before. Worked pretty good, I was single then though.