New built Cougar 2 TEAM
- minichamps11
- Approved Member
- Posts: 377
- Joined: Mon Jan 14, 2008 11:49 am
- Location: Midlands, UK
Re: New built Cougar 2 TEAM
Yep, had the problem with those front & rear screws too. About the only bit I used to properly break was the front suspension plate (moulding front wishbone pivots go through). Schumacher updated it over the years (there are at least three different versions) and it eventually got a FRP strap to reinforce it when the Nitro cars were released. Apart from those bits, the Cougar was bombproof. The chassis wasn't a real problem as you could always bend it back by hand....nice cheap fix
My Tamiyaclub Showroom http://www.tamiyaclub.com/member.asp?id=23061
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 11 Replies
- 3280 Views
-
Last post by CNA75
-
- 2 Replies
- 1152 Views
-
Last post by Daddeo
-
- 15 Replies
- 2193 Views
-
Last post by Incredible_Serious
-
- 5 Replies
- 979 Views
-
Last post by factory team gair
-
- 19 Replies
- 2651 Views
-
Last post by Retro rc
-
- 0 Replies
- 917 Views
-
Last post by CATS
-
- 27 Replies
- 2482 Views
-
Last post by orangemazda
-
- 5 Replies
- 1141 Views
-
Last post by moozo
Who is online
Users browsing this forum: No registered users and 1 guest