I need a screw.....?
I need a screw.....?
Does anyone know the size and count of all the screws needed for an "A" stamped RC10? Actually, I need the screw size for the chassis screws that attach the tranny to chassis, steering blocks, etc. I forgot the car at home and I'm 220 miles away. I'm in the valley where there is a Bolt and Screw shop that has every imaginable bolt and screw, but I don't have the size and count of screws needed. Can anyone help? Thanks gents.
In Christ,
Joel C.
Joel C.
-
transamman908
- Approved Member
- Posts: 770
- Joined: Sun Aug 03, 2008 2:25 am
- Location: East Coast
- Has thanked: 1 time
- Been thanked: 5 times
Re: I need a screw.....?
18 or so 8-32 x 1/2" is for the chassis/trans/mounts
The servo saver gets 8-32x7/8"
The above heads on those screws have a 100 degree angle
4-40x3/8" and 4-40x5/16" are good to have also.
The servo saver gets 8-32x7/8"
The above heads on those screws have a 100 degree angle
4-40x3/8" and 4-40x5/16" are good to have also.
If things seem under control, you are just not going fast enough.
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 8 Replies
- 1101 Views
-
Last post by Jedi Master
-
- 4 Replies
- 842 Views
-
Last post by Optinutz
-
- 3 Replies
- 797 Views
-
Last post by GAMMACRUSH
-
- 2 Replies
- 340 Views
-
Last post by Diggley
-
- 24 Replies
- 5779 Views
-
Last post by janaya
-
- 4 Replies
- 1265 Views
-
Last post by Synchrocnc
-
- 2 Replies
- 749 Views
-
Last post by mk-Zero
-
- 15 Replies
- 2793 Views
-
Last post by fakiee
Who is online
Users browsing this forum: No registered users and 48 guests