I will have a Parma Euro Panther project through the winter. Not restoring an old car but building a car from parts, again.
Got a prototype chassis and some special parts but there are lots of missing parts also. Have an exploded view drawing but dimensions and part # are unknown. Someone have a manual, if there was one?
Some questions on hardware, what size/type are screws and nuts used for front end and t-bar?
Also what size is the brass (?) ball used at the ballcup for the center dampener, the one which uses silicon tubing. Have that dampener but the ball is missing.
Parma Euro Panther project
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 64 Replies
- 7242 Views
-
Last post by TomiS
-
- 5 Replies
- 1113 Views
-
Last post by karnivool
-
- 5 Replies
- 897 Views
-
Last post by Charlie don't surf
-
- 14 Replies
- 4890 Views
-
Last post by littleVETTE
-
- 6 Replies
- 1184 Views
-
Last post by Bullfrog
-
- 12 Replies
- 2488 Views
-
Last post by isobarik
-
- 3 Replies
- 1443 Views
-
Last post by clinehobbies
-
- 17 Replies
- 3142 Views
-
Last post by spru
Who is online
Users browsing this forum: No registered users and 3 guests