Rc10ds front bulkhead - arm mount width
-
- Approved Member
- Posts: 285
- Joined: Fri Jun 13, 2008 6:19 pm
- Location: CHICAGO USA
- Has thanked: 31 times
- Been thanked: 39 times
Rc10ds front bulkhead - arm mount width
Can anyone tell me the width of the front bulkhead where the inner hinge pin passes through? I trying to figure out if standard off road rc10 front arms would mount to this bulkhead. Thanks
- MarkyDents
- Approved Member
- Posts: 1019
- Joined: Sun Jan 10, 2021 11:52 am
- Location: Staten Island, N.Y.
- Has thanked: 1335 times
- Been thanked: 509 times
Re: Rc10ds front bulkhead - arm mount width
I wouldn’t say these measurements are exact, to do that you’d better to get the caliper around the parts when free from each other. Hopefully this helps though
Apparently the site added today’s challenge of trying to read the measurements upside down
Click on the pics and they will go right side up
Who do you race for ?
Me……. I race for me.
That’s impossible, I was told you need a sponsor to race.
Hey Cru ! Go balls out
Me……. I race for me.
That’s impossible, I was told you need a sponsor to race.
Hey Cru ! Go balls out
-
- Approved Member
- Posts: 285
- Joined: Fri Jun 13, 2008 6:19 pm
- Location: CHICAGO USA
- Has thanked: 31 times
- Been thanked: 39 times
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 2 Replies
- 454 Views
-
Last post by littleVETTE
-
- 12 Replies
- 1383 Views
-
Last post by RC104ever
-
- 3 Replies
- 966 Views
-
Last post by Typpo
-
- 6 Replies
- 1191 Views
-
Last post by Mindwarp
-
- 11 Replies
- 3758 Views
-
Last post by Coelacanth
-
- 7 Replies
- 501 Views
-
Last post by Daddeo
-
- 6 Replies
- 1586 Views
-
Last post by KidAgain
-
- 60 Replies
- 10259 Views
-
Last post by KidAgain
Who is online
Users browsing this forum: No registered users and 1 guest