RC10Talk - The Net's Largest Vintage R/C Community

I work as a pizza delivery driver since losing my pretty decent job at IBM and returning to school. There are some good things about it, I work with a lot of pretty girls which is the only thing that makes up for the fact that managers in the food service industry usually are complete a-holes. Most ...

I'm also glad to see this thread here. I am currently on the fence about buying a new PS3 just so I can play GT5. I have always been a huge fan of Gran Turismo but I have wanted to see some opinions on whether or not it would be worth it to buy a PS3 just to play GT5. Total for both would be 360 buc...

You mean the lock nut on the end of the diff? It's a 5-40 nylock. How did you strip one of those? I was just rebuilding the diff today and tried to put it back on and noticed the diff was slipping real bad. Took a closer look and saw that the bolt just came right off and the threads were pretty muc...

Does anyone know what kind of bolt goes on the end of the differential shaft? Mine stripped out and I don't have any more, there is not a part number in the original manual.

Does anyone know what size bearings to use on Houge bellcrank steering?

Does anyone know what kind of rims those are that came with your car? I have the same five spoke front rims on my RC10 and I was curious what size they were, and what kind of tires I could possibly mount on them. I had to use some spacers made by CRC to get the RC10 bearings to fit and would like to...

Charlie don't surf wrote:Judging from the pics of that track, 10x3 to 8X1

My ESC will only work with over 13T. I also was thinking I might need something a little mild so I can get a little longer runtime.

You guys have been helpful putting my old RC10 back together. I have replaced worn/damaged parts on the suspension and have taken everything apart and cleaned and rebuilt. I am planning on racing it at my track and need advice on what would be a good motor to run on a pretty large outdoor track that...

do you have the short arms? if so i would just upgrade to the longer arms and replace the tie rods. other than that the best place to find replacement short arms would be ebay of from one of the member here. honestly you will like the rpm arms you found on tower. I do have some extra tie rods that ...

I can't tell you what will work... but just use all those naysayer's comments as fuel to whoop some ass! I've heard too many of those comments about me running brushless in an old RC10T! Beat them, then tell them to go buy an OLD car! P.S. it is my understanding that most, if not all parts, origina...

I put my old RC10 back together and took it to a race last weekend and ended up breaking a rear hub carrier. I wanted to know if I could use this to replace it: http://www3.towerhobbies.com/cgi-bin/wti0001p?&W=001705346&I=LX2557&P=K I also looked at these other replacement parts from RPM...

do you have another radio or receiver you can swap out piece by piece to see which one is the problem? Or at least a matched set of crystals? Todd No I don't. I think it has to be either the crystals have gone bad or the receiver may be damaged. I didn't know if this was a common problem or not sin...

I have finished cleaning up my vintage RC10 and have an old Futaba Magnum Sport radio and receiver in the car and for some reason it glitches like crazy whenever the throttle is applied. I have checked the capacitors on the motor and tested all connections on the car. The motor and ESC are also very...

Here is what I have.

this for a goldpan? u wanna go for vintage look or just something to run on them? pm , i got a set of brand new unused original tires on rims for the original rc10. Yes. It's pretty much a completely stock goldpan RC10. It has a LRP ESC, receiver and servo from the Magnum Junior I bought for it aro...