RC10Talk - The Net's Largest Vintage R/C Community

Please note, this thread is not a solicitation to sell anything - I have already requested permission to access buy/sell and I know this is not the forum to sell in;; rather to ask a question: I have an original box for a RPS/Yokomo Dog Fighter RPS SE, 1985 or 1986, in remarkably good condition over...

Are you sure it's 21, and not something else (perhaps the 1 is first, like 12 or 13 or 17 or something)? if the writing was sloppy it could maybe look like 21 if it were upside down. just asking because 21 seems like an uncommon/unlikely wind. there was plenty of 27 turn motors (stock), plenty of 19...

It may not look quite as nice, but soldering the + lead to the OUTSIDE side of the positive terminal on the connector will give you a lot more distance/room between the + and - terminals. Solder the - terminal first, with say a popsicle stick between the + and - terminals to keep the gap free and cl...

To add another "data point": I picked up some B4 fronts (P/N 9588), and they will need to be spaced out more than I realized to fit (JrxPro SE). They sit just about perfect with a spare bearing on the front axle prior to slipping the wheel on. it's enough that the stock Losi plastic wheel ...

I'll try the XXX thrust next time, thanks for the tip.

The XX retrofit tranny instructions call for LOSA3071 which is the part I was having a hard time finding.

don't know if it will help anyone but thought I would share. I have been looking for a thrust bearing for an XX diff (well, actually, the XX diff in my retrofit tranny, but whatever). I had some difficulty finding one online. I just happened to be wandering through the local hobby shop and came acro...

I can't say if they are the same, but you should be able to use the pictures and visually at least tell if they are close.

The A5023 part is correct for a JrxPro and SE variant; it's entirely possible that the bottom spring cup/collar is the same for your Jrx2.

pictures for reference can be found on these pages

http://www.losipartshouse.com/servlet/the-21446/LOSA5079-Shock-Ends-%26/Detail

http://www.losipartshouse.com/servlet/the-21413/LOSA5023-Shock-Spring-Clamps/Detail

are they different from those used on the newer cars, such as P/N A5079, A5023, etc.?

I went ahead and ordered the A1017. fingers crossed, will post info when I get them.

Regarding the parts for the Jammin' steering enhancement kit for the JRX-Pro.. does anyone know if the front spindle carriers are the same ones as the LXT, P/N A1017? They do LOOK the same....

I'd be happy to trade them off for some wide 2.2 b2/b3 wheels where the bearing fits snug. Do the genuine Associated fit? are there any other options?

I have three sets. all brand new, never seen glue.

I picked up some NOS Pro-Line 2639 2.2" front wheels for the B2 and B3, but am having a problem. The inner bearing fits perfectly properly, but the outer bearing falls into the wheel and does not fit snug. I used my caliper, and the inner bearing area is 0.3745 (pretty much exactly what you wou...

I'll paypal you whatever it costs to ship them + $20 if you fetch them from the trash and ship them to me!

you might try heating the exposed wire end you want to solder for several seconds with a lighter or small torch. if there is some kind of coating on the wire, this MIGHT burn it off. hold the wire with needlenose or pliers so the heat doesn't wick up the wire and burn up the insulation. or just send...