RC10Talk - The Net's Largest Vintage R/C Community

Very nice, was wondering if i would find someone with a graphite chassis turbo inferno. I bought a turbo inferno in 1995 and added all graphite chassis, towers radio plate and front support, along with the duratrax fiber four disc brake system. The parts were dirt cheap since it was a discontinued i...

Very nice!!! Great to see collectors appreciating this line of buggy!!! I have two in the rebuild stage along with a Progress for a runner.

I did not recognize your user name until i jump to the link. Small the world of RC forums. Nice resto!!

I have found another oddity of this Gallop compared to my Gallop with silver shock and my Progress and the parts Gallop with silver shocks. The. Gold shock Gallop has thicker rear shock towers. Now I have to think that this is a revision that was close to the last before the MK II or it was in a tot...

Ok, i have two 17t pinions in the mail mod .8. Now i need to source some 4 & 6 mm spacers to shim the bearing sets i will be putting this Gallop and the 2nd one i acquired this week. And to clean up the shim job someone else did with the Progress i got last week. Will have some partial assembly ...

Good choice going chain, i always liked the noisier sound of chain drive vs the silent running of the belt. Plus chain drive sounds more rough and out on the edge nowadays than belt does so it gives the nice feel.

I would also second the idea of a better lit pictures of your anodized chassis.

Been a little busy myself, over that last two months the mail lady has been looking at me kinda funny,(yes i did answer the door in my boxers and t shirt ONCE) but i think i has to do with the two and 1/2 Kyosho Gallops, a Kyosho Progress, two Nichimo Exceed Pro 433's, a Turbo Raider, three Stinger...

Been a little busy myself, over that last two months the mail lady has been looking at me kinda funny,(yes i did answer the door in my boxers and t shirt ONCE) but i think i has to do with the two and 1/2 Kyosho Gallops, a Kyosho Progress, two Nichimo Exceed Pro 433's, a Turbo Raider, three Stinger ...

Nice javelin. I have to pick up a re-re orange cage and rear support post for my body less parts bin build. Love the optima series!!

Would be nice to have the cash to ano my dull vintage chassis too much time polishing them burnt myself out with my Salute

mine has one crack at the rear transmission mount upper screw hole.

yeee haw. Finally got my hands on an Nichimo Exceed Pro 443 and have replaced all the bushings except the rear inner races on the axles. But I have a problem bleeding the front mono shock. Has anyone ran into a problem bleeding the Nichimo Exceed or Spirit front shock? WP_20180126_11_30_06_Pro.jpg W...

this one won't be run but I have another in the mail and my progress just showed up today. Would yo have an idea of what gear could replace the final pinion in these beasts? th original is butter hard aluminum and the one in my progress is done shot.

Yay bearings have arrived, now to reassemble. Kyosho Progress will be picked up from the post office tomorrow so i can tell what shims to use on the rear diff of the Gallop.

what about the brushes? this one has the lay down style brush hoods I have only rear the vertical ones is there any performance advantage or maintenance considerations vs the old style?

just use these Tamiya #42137 ~ Competetion O-Rings for Oil Dampers i have rebuild a set of baby golds for my Gallop and they work great and don't leak.

Hello Hoseman50,

You need to go to this page: https://www.rc10talk.com/viewforum.php?f=52

It shows what you need to do before requesting parts or conducting any sales, trades or bartering.

Hope you enjoy the knowledge gained from being a member of this forum.