RC10Talk - The Net's Largest Vintage R/C Community

This will be the initial group getting measured. Most are used, but still straight. Measurements 1 through 9 refer to the graphic in the first post.
. .

Hello!

Thank you for starting and contributing to this discussion and supporting our '89 Stealth RC10GX Worlds replica
And thanks to Jolon for pointing me to this great forum

And of course any questions/support you need I'm here to answer/assist in any way I can...

Thank you all!

Thanks guys!! RC10Talk is the "real" forum for RC10's :wink: When studying the pictures of Masami’s car I found a couple of additional holes drilled in the rear shock tower. Also cut an original bulkhead to shape. Cut, shaped and drilled the steering bell crank as per pics of Masami's car.

Some reproduction bits for the GX and future builds. Very nice! Would you be able to point me in the direction of the source please :D :D well dont know if it's okay to post here. If not admin can delete. Facebook: https://www.facebook.com/fan.chan.3910 Instagram: https://www.instagram.com/chengfan...

Here's a nother question for you: What you you make of the slipper/spur on tis pic of Masami's car at the '89 worlds. It looks like a Robinson spur gear, but what is the dark area? Was there a prototype slipper with the spur squeezed between the slipper hubs? It looks like Masami has a gear cover wi...

A little update.
Du-bro 1/16” collars that hold the wing in place.
At the front: Xray 5.8 mm pivot balls are as close to original Yokomo as it gets. Looks much better than the long Kyosho ones.

Looking really good sankil! :D Love the work you have done with the dremel on those front arms, all I need is the courage to do the same! :lol: What front inner hinge pin did you use? They look perfect! I used the front truck ones Associated 7209, and well they are about 3mm too long. Thank you blu...

About those hard anodized shock caps on the -89 Stealth.. It's not going to happen for my part so I'll go for the next best thing. Enamel paint! With that said I'm partially color blind so don't ask me for the color blending. I've been at it for the past week :twisted: but I have used the following:...

I will scan the item as a pdf which retains the scale. Then I import it into cad as an overlay. Then I start by picking a hole to base everything off from. I measure the actual part hole to hole, triangulating it as much as possible. Then in cad you can draw circles with those lengths, and where the...

Not much of a build thread as its almost complete few decals to find and apply Wasn't really sure which way to go with this (replica wise) as there was only 5 of them with very few pictures as AE wasn't keen on photos being taken. So of the four non Masami cars i decided to go with some kind of Butc...

The final pieces of the puzzle.