RC10Talk - The Net's Largest Vintage R/C Community

1911Colt wrote: ↑Wed May 17, 2023 11:07 am At least one jerk on here votes for every Schumacher that is ever entered. Don't ask me how I know

At some point I intend to get that vote

There are a lot of excellent entries. I really think getting to make multiple votes (like 2) would make for some interesting results.

Remove all metal or you will end up with rusty steel parts and rust stains on the nylon pants.

TRX-1-3 wrote: ↑Thu May 18, 2023 6:59 am F'n Truck

It's not pretty, but it fills a slot in my hit list. And now that I have it, that means another one cheaper and nicer should be popping up any moment. Maybe I should go wash my car too just to get the universe properly in motion.
.

Have you tried these? They are the MIP parts that fit the CVDs for RC10 through RC10B4 and T through T4.
.

I'm happy to see Autographics has a new owner that's restarting production of the old decals. I'm waiting on Rodney racer to get back in print.
.

jcwrks wrote: ↑Wed May 24, 2023 10:14 am My attempt at dry humor failed. I left off the wink emoji and part of my post didn't submit.

I also didn't understand your previous post. It seemed like a good way to mess up a diff tube by unnecessary removal and reinstallation of an already correctly installed gear.

...time for 2 motors!

romulus22 wrote: ↑Sat May 27, 2023 11:39 am C705F8C1-F2B6-4E3C-BBE1-9ABD8CD119D9.jpeg

I leveled your flight path a bit.
.

Is that the regular gunpowder motors?

I feel like this gear drive should be the starting point for a home brew airboat or hovercraft. The Leisure Modified motor attached is nice though and might have to get swapped out for a runner instead. . PXL_20230606_185206590~2.jpg . The endbell markings on the AYK Magnum confuse me. The + and - m...

Hot Trick was an aftermarket parts company that most used flat metal plates (I think typically aluminum) for replacement parts. That looks like a Tamiya Fox that got the plastic chassis replaced with the Hot Trick kit. Well, maybe is started out as a Tamiya Fox. There's a few RC10 parts in the mix t...

I agree, I don't see any value in these markings. They make no sense to me.

It looks like I'll have to find a pinion gear to use a replacement motor. The pinion is pressed on. No set screw or flat spot on the armature.
.

I have a puller that might take it off, but I'm going to think about that for a while.