RC10Talk - The Net's Largest Vintage R/C Community

Post my real build before the re re invasion lol

Looks like his car had staggered rear caps, would explain the hub difference. A local Trinity driver had a host of different hub widths for the Evo10 SS...so it's likely a one off on Joel's car When you have time, can you check yours on the rear axle and see if it takes a 8-32 nylon nut? This new L...

Looks like his car had staggered rear caps, would explain the hub difference. A local Trinity driver had a host of different hub widths for the Evo10 SS...so it's likely a one off on Joel's car When you have time, can you check yours on the rear axle and see if it takes a 8-32 nylon nut? This new L...

Looks like his car had staggered rear caps, would explain the hub difference. A local Trinity driver had a host of different hub widths for the Evo10 SS...so it's likely a one off on Joel's car When you have time, can you check yours on the rear axle and see if it takes a 8-32 nylon nut? This new L...

Looks like Jason beat me to it. I will still go over some other things that may have been missed as I get around to the car. enfXxQSQUDg RC Vintage did a video on it as well and it appears to be pretty good quality. He's looking at the car in a strictly race car though, he deosen't seem to care much...

Uh oh, what I miss? :lol: :wink: I know the MIP cvds is one, but it at least has the cvas. I also didn't discuss trimming the wheels. Well, I thought your video was excellent and definitely plan to refer to it for my BK build! I'm amazed with all the tiny details; were there any parts that Brian di...

Here's the build thread of my car. There's a pic of the bulkhead just sitting on the bench after the mods. Also notice my screw up on the antenna mount. I angle cut the wrong side by accident.

https://www.rc10talk.com/viewtopic.php?t=41196

I dony know what's next, but it should be this ...

It’s all done!

Factory Works Ten4.1

Factory Works Ten4.1

https://www.rc10talk.com/viewtopic.php?t=50534

Not sure on the wing tubes. I'd have to measure and compare them to others

Bulkhead ball stud will be the same as the rear hubs and castor blocks (.300 I believe)

You may have to chamfer the holes on the nose plate sligthly to allow the screw to seat properly.

I couldn't help myself. Everything I've read says this is a great car TLR put together. Hopefully worth the wait.

With all of my rc10 runners, new and old, using modern hex and offset wheels in the rear for now, I was excited to finally see the pioneer wheels available. Had to get one of each color!

few things at a glance. I'll add more details to this later. A good amount of this was in Jason's video. -Update 6/9/25: obviously no longer "at a glance" Updates will happen anytime I find new info. Information here is In regards to the car as it raced at the '93 IFMAR Worlds. Note that t...

I'm going to mention this loudly: The BOX ART is not correct!! There I said it. Biggest take-away here with the paint is that the drips on the actual car are much shorter, Also there are 7 distinct blue fields on the car. 1 Central and 3 on each side of it, decreasing in width. The lower ones only h...