RC10Talk - The Net's Largest Vintage R/C Community

I can only guess that this is one of the earlier examples, which would be supported by the fact that it was used as a mag review car. The silver angled metal parts on the hubs (I have also seen golds available) might also hint at this perhaps? I have gold equivalents that i might swap out at some po...

This is my 2nd LosiXX. Fairly rough to begin with but I think it turned out really nice. Since my build thread, https://www.rc10talk.com/viewtopic.php?f=27&t=47030&hilit=losixx, I added a Speed Works Pole Position motor, a Tekin TSC 410 S2 ESC and a Futaba FP-R112JE receiver. My favorite mod...

Really pleased , very hard to photograph as it's a clear resin .

I think i'm done here never going to be an exact replica but you get the idea plus a nod to all those who qualify 11th

And big thanx to Andy Cooke for all his hard work in making it possible.

Been remodelling the driver figure , gone is the button up shirt of the traditional Marlbro Man driver figure , now it's skinny arms in a T-shirt.

Well it came out….ok…I am not much of a paint/body guy and removing and reapplying the decals definitely wasn’t a good idea…oh well I can always order more I guess but here it is…at least for now. I’ll see about replacing the wing buttons with the blue B4 versions if they become available at a decen...

So last weekend I went to the Jconcepts INS race at Adrenaline R/C Raceway in Winchester, VA. I raced this in the 17.5 Independent class. The car worked pretty well. I tried some different setups.... mainly tire and spring changes, but by the time the mains came around on Sunday I was back to where ...

Racing this weekend. June 3rd.

No surprises what this is , the Sand Rover was my first rc car , never really great and its taken me 40 years or so to come back too , a lot of CAD and 3D printing involved in the lights and dashboard that are both illuminated as well as the engine , gearbox cover , the celebrity driver's head and S...

Tamiya hybrid buggy, built mostly with Blitzer Beetle parts. It also uses parts for a Stadium Thunder and Hornet. https://www.rc10talk.com/viewtopic.php?f=32&t=47655 The yellow CVA shocks are from a Vanquish and the CVD shafts are for a TA-02. It uses AmPro upper and lower chassis braces. The wh...

Kyosho Optima Pro, last of the chain driven Optimas. Period correct LeMans 480 SPA to finish it off.

My contribution; a freshly built Ultima SB Dirtmaster. RB5 based and rear motor, so already more "retro" than the current crop of buggies out there. I built it as a nod to the Javelin, so some red Exotek alloy bits on RB6 Velvet shocks, a few RB series parts like lightened top shaft and sl...

Wired up and installed a new Hobbywing 1060 in my finally finished, rebuilt SRB.

RC10DS White Parts Special. A project that was almost complete minus a body. I was gifted a Vaterra 1967 Mustang fastback body a few years ago. I decided to mount that body onto a DS chassis for this months's BOTM. The original DS wheels were swapped out for a set of Protoform VTA wheels. This was m...