RC10Talk - The Net's Largest Vintage R/C Community

That was the first thing I tried but it literally doesn't fit in any way that the trans would look even close to original. I even pulled apart my mini t 1.0 and it's diff is even bigger. I measured the stealth and that diff is far too big for that as well.. I need to find a 1/18 diff that is smaller...

Do the 1/16 traxxas vehicles have a differential available for the center trans? If not the pinion setup is probably just as viable.

Ok I see they do have a center diff available, I just ordered a cheap trans from ebay we will see. I am still open to other options as well

Well the mini revo center trans is a no go, OD is only 1mm smaller from 20 to 19... still too big. I might look into the micro cars or just make a trans case that doesnt look right... or make a trans without a diff whee

No biggie man, the old 6 gear is a funky size to try to make work, It just may end up without a diff as it would be quite easy to just use a series of pinions of appropriate sizes to replicate it.

uh oh, how did I get here again? I burnt myself out there pretty good beating myself up trying to figure out a transmission for my mini rc10. i have seen the new jrxt but lack the funds for one, i have been checking on chassis availability nearly every other day and once I can get a couple I plan to...

Starting working on assembling the mini LXT. Going to need to rework the front and rear hubs as there isn't enough meat on them to be durable at the ball stud holes. But its coming out pretty good. I have an idea for the rear axles, hopfully the lhs has some of the parts i need. Also seems that the...

Looks great

2157 just arrived, time to get to work. lol I am amazed I got so close on the dimensions, the chassis is almost perfectly right right length but the flat sides are a bit longer that what I ended up with. This could be my error or it could be the designers that shrunk the design for the mini jrxt adj...

Ahh I see, I guess my design was a little more studious

as for the sideguards I will work up some designs this weekend I think, going to grab a bottle of ca debonder tomorrow to work on ungluing 57s tires. The tires seem undersized to me...

finally got some time to do some measuring and modeling, I am actually surprised how close the chassis are together, I was only measuring the new chassis shown in red, I copied the model for my no cutout jrxt chassis and layed it over the rough model of the new chassis and width and length is almost...

Working on a rough draft of some sideskirts, is a bit difficult with my pattern in this condition lol I think they will be thicker than stock when I have them ready, printing them at .5mm and then scaling it down would be a pain. this is just a rough modeling, trying to get the angles worked out fro...

How's this? First print in over 6 months.. wiped the bed down plugged the card in, pressed print. https://cults3d.com/en/3d-model/game/losi-mini-jrxt-chassis-skirts it is a quick toss together, I would recommend printing on fine settings I could probably beef them up somewhat and add some resistance...

This build makes me jealous, it is so awesome finding one like that

I have uploaded modified versions of my Junior T and LXT wheels sized for the tires from the Mini Jrxt, granted you will need to unglue tires from mini jrxt wheels to use them... I have left the 1.6 inch wheels for rc10 rear tires as well. I am trying to get some additional tires to make my jrxt 3 p...

Even though I dont have an undamaged tire to test them with I modified the files for the Jrxt rims and tossed them on cults for testing. Feel free to try them out and let me know what needs modified. I am going to work up some disks for the LXT wheels next and maybe a printable mold that could be us...