Can somebody with an SC10 please measure the wheelbase, at standard right height and with the chassis bottomed out? I'm trying to figure out how much to stretch a 10T chassis to fit the body. My original plan was to line up the wheels in the fenders when it bottomed out, but that makes the wheelbase about a mile long at full droop. Thanks.
Has anyone here ever run the nose plate in the forward position like the trucks do where the chassis is 7/16 longer? I could have sworn I did this back in the day and my friend swears we did too but I don't know of anyone else who did. Back then I...
Last post
There are 2 tracks near me. The closer one to me is outdoors. It has always been fairly poorly maintained but today and tomorrow they are making some pretty big changes to it. I'm told it will be much tighter than it used to be. The other track is...
Why were there several options for the wheelbase on the 10T yet there is little mention of using it for tuning? For example the noseplate has 2 sets of holes about 3/8 of inch shorter or longer. My B chassis has two sets of holes for the rear a-arm...
Last post
Yup, just new holes to make the mid motor configuration work- we used to do the same thing, but with a graphite car so you didn't have to cut the tub.
I am away from home for a few days. Can anyone let me know the wheelbase of an RC10 please? ie, distance between front axle and rear axle centres. Ideally for a Worlds, or any gold pan with the nose in the normal shorter position. Roughly is fine as...
Last post
I just measured mine the other nite and at the short wheelbase it was 275ish I believe. The long WB was like 285ish.
I guess the simple question is how much can you shorten a T4. A half inch or so would be plenty. Can you swap in a B4 chassis?
Just asking because I've got a body that would work much better on a shorter chassis.
LMK, thanks.
Last post
You can in fact use a b4 chassis but it will be much harder to drive like slotcarrod said. If you want to make the t4 into a buggy, the j82 conversion kit from jconcepts is really cool
I've searched for this a little and did not get any results. I've got a project to build my old 6 gear RC10 with a custom made graphite chassis and RC10 conversion kit for a Tamiya Porsche 935 body. The body has a 239mm wheel base, and I...