RC10 pan chassis, what is it?

Post by **CON2** » Fri May 27, 2011 10:32 am

Hi all,

Got this in a "job lot".
It's been re-sprayed blue and there's a "few" extra holes.
The milled bits, one is rough could have been home done.
Back motor guard, very neat, but cut down?
The sides seem to be thiner than any other pan I have??
Weights 152g

Is it anything special, or a homebrew???

Cheers.

Post by **CamplinP** » Fri May 27, 2011 10:34 am

Looks to be a home brew to me. Kinda cool looking though.

Post by **THEYTOOKMYTHUMB** » Fri Jun 03, 2011 10:56 pm

While I think it was just slimmed down a bit in the rear, it does look like it was very well done. I think it would be a great start for an old/new build.

RC10Talk - The Net's Largest Vintage R/C Community