Done a little more work on the truck...
Made a bumper out of aluminum since the plastic one was shot, almost looks identical.
Replaced some of the stock screws with allen cap head screws
Got new belts from eBay, straight from Korea but had to search for 870c not yz10.
Cleaned the RC10 shocks and put new oil in them only to have the caps leak all over the place and attract dirt. So I removed the stock plastic washer things and used some plumbers thread seal tape and it worked like a charm.
Fixed my old Novak 610RV ESC since I burned out a few the Mosfets. I managed to track down some replacements so I now have reverse again.
Have ordered the Corona 2.4Ghz DIY Module & RX for my old Futaba Magnum Jr from Hobby King (horrendous shipping time but good prices) look forward to trying this one.
Started my effort in getting Kyosho CVDs...
This thread
http://www.rc10talk.com/viewtopic.php?f=29&t=15474
inspired this decision, along with a lack of JG truck rims. Have enough rims for now but don't want to keep having to find more, plus I just don't like the yz hub design all that much.
So...
I purchased some Kyosho UM510 CVDs which are 62.5 mm and for my version of the YZ they are way too short.
When installed they don't even reach the diff except in maxx compression of the suspension then they just kiss the diff.
So I pulled out all my drive shafts to measure them and they are all identical, each one from joint to the end of bone is 68mm.
Front and Rears, which is different from the thread I linked above. Guess i should of measured them first lol
Guess I have first hand experience now with my car being different from other yz's just like I have read in many other posts.
Looks like I'm going to have to go with LA231 shafts which are 68mm
Hopefully they will fit correctly