I have a few Hobbywing brushless esc systems. They offer the best bang for the buck. They are great if you are just running with friends and can be raced if need be. These are non sensored and can be reversed by changing any two motor wires just like an ac motor. If you pick up a programming card you can adjust the parameters much easier then trying to do it without. Get the card, you will not regret it.
Anyone know a good source for a reverse rotation brushed motor? ROAR91 stock. I have an Superior Racing Spectre Left-side-drive pan car and all my LSD motors are pretty trashed from racing them so much. They were pretty hard to find back then even....
Last post
I would contact the folks at Holmes Hobbies. They mostly deal with crawler/puller motors but can build reverse rotation motors. They also have repair parts on their site. You might be able to rebuild one of your old motors.
Hi, I have an 8th scale LRP SPX8 that I used in a Mugen MBX6 Techno conversion that worked great. Now have a Team C T8E that I am trying to install all of my electronics in but cannot get the esc to reverse rotation. It does not matter which...
Last post
I have had the LRP sx8 since shortly after buying the MBX6 Tekno conversion buggy. I got the LRP because of the LRP reputation, I use LRP X12's in my Losi 22 and my 12th Corally and they work flawlessly. It was just dumb luck that the esc and the...
I was wondering if adding an idler to my spur gear, than driving the idler off the pinion changes the overall ratio of the transmission.. I've heard of this being done, but nobody ever got in to the dynamics of the ratio, like does the idler now act...
Okay just hooked up my castle 4600KV and Sidewinder 2 in my vintage RC10 the motor runs in reverse, when i pull the trottle so I initially just reversed the channel on the Flysky controller but also read that you can just switch two of the motor...
Last post
What everyone else already said. The ESC and sometimes motor instructions almost always say to switch 2 wires to reverse motor direction.
Hi, new to the forum and in need of help please.
I'm building a tamiya midnight pumpkin, all was going well till I put on the rear wheels and found that when I manually turn one wheel the opposite wheel turns the other direction.
I've revisited the...
So i would like to run my BL motor on my A n L trans as a mid but needing to reverse the rotation of the transmission .
I have been reading a few ideas from the net and it seems if you change two of the wires from the esc to the motor ie a to c and...
Last post
switching 2 phases only works reliably with sensorless mills!!!
Guys, the first time it happened, I thought I had Alzheimer's or something...but I've confirmed this behavior and wonder if any of you have experienced something similar?
So, I installed an LRP AI Automatic Super Reverse in my Optima. Unlike most...
Last post
Call Team Associated, They do the customer service for LRP in the USA.