Out of a trade with my new buddie Vintage 88 I got a stealth ready roller no trans and I thought I had the perfect trans for it. One of of a T3. I recived my good condition gold pan today and got all giddy and started to try to put my trans on it when it hit me. Dangit the gearbox is too fraking long..grrrrr...... I realize that I could make it fit but it means either hacking the beautiful white plastic bulkhead or cutting the nub off of the front of the trans off and hope to trust 2 screws holding it on. Niether sound like a good idea. So I have 2 more options either build my own custom bulkhead or hangit up send the trans with the rest of the t3 parts off to Vintage 88 because he needs one and either adapt a b4 trans or wait till I can get an older stealth. So on to some pics. Here is the chassis these are the pics he sent me but it came exactly as pictured
imagejpeg_2_17.jpg (47.46 KiB) Viewed 1339 times
imagejpeg_2_17.jpg (47.46 KiB) Viewed 1339 times
imagejpeg_2_19.jpg (49.68 KiB) Viewed 1339 times
imagejpeg_2_19.jpg (49.68 KiB) Viewed 1339 times
imagejpeg_2_20.jpg (42.72 KiB) Viewed 1339 times
imagejpeg_2_20.jpg (42.72 KiB) Viewed 1339 times
and the trans.
and the two don't mix
Attachments
Super phenominal cosmic plans! itty bitty bank account.
as you have found out, they aren't exactly the same. You could modify the bulkhead and mount the trans and arm mounts on a small plate with a cutout and it will all line up and work. Or you could cut a hole in the pan and mount the trans direct. either way you need to get fancy with a upper brace mount. There have been a few guys that have done this. Soniccj5 did what you are attempting to do:
I have some templates, but they are a little "sketchy". Let me see what I can get together. I have also tweaked them a bit for the second pass. Let me see what I can get together.
