hey daryl, the prototype car of yours that you guys ran at the worlds back in the day, did you ever pull that down from the rafters in the garage for some pics? unless you did already and i just don't remember. that's possible.
hey daryl, the prototype car of yours that you guys ran at the worlds back in the day, did you ever pull that down from the rafters in the garage for some pics? unless you did already and i just don't remember. that's possible.
Too many things around the house to do and my wife makes me go to work every weekday! I need to start a thread in the Gallery section - if I haven't already? Cannot remember if I have
A couple of updates... Its been a while and I have pretty much jumped to the end. This car has an MIP Transmission and the parts are Worlds car themed,
The fiberglass car is just all parts black and hard anno'd shocks. I haven't dyed the transmission case yet though. Its a 6 gear with Thorp 48 pitch.
I plan on electronics eventually... But that will come after bodies I think. That will be a while because I will search forever for the right things. Right now the goal is to get the last of these three cars into a roller and I have a couple other projects to finish and a few more brewing,
I plan on electronics eventually... But that will come after bodies I think. That will be a while because I will search forever for the right things. Right now the goal is to get the last of these three cars into a roller and I have a couple other projects to finish and a few more brewing,
Yes, I know your situation: You have not even finished one project and already starts the next one
Okay, so yet another project in the works... I have pieced this one together with parts. Still need a couple (Listed)...
I picked up the truck about a year ago and haven't done anything with it till now. But decided while I am waiting for parts and...
Last post
Its very thick. Even in the places that the original was not very thick, maybe too thick in some places... So ya it seems very stout. The Detail could be better on the window net, but everywhere else is not bad.
This is my first build that wasn't just a clean up of something that I purchased from ebay or other sources. It is a 6 gear with a purchased powder coated orange chasis from Treehugger. I acquired the 6 gear tranny and tecnacraft turnbuckles from...
I'm going to first complete the rebuild of the incomplete one, the only reason it never got rebuilt was because the LHS closed up and I needed two bearings for the rear bearing carrier but didn't know the size of them. Found a semi-close LHS and...
Last post
Guys must have bright monitors, I can't read it. :shock:
I've been interested in building one or two of these for a while now so here's the early beginings :D The plan is for one runner and the other a shelfer both being open ended projects with different parts and setup.
It was a tough project to get...
Last post
Thanks guys! 8)
Before I made the fiberglass chassis I shortened the runner chassis/nose tubes and moved the servo holes backwards accordingly. If you're wondering, the spacing is the basic equivalent of the hole spacing on a truck nose plate. I...
Welcome to my Forgot how many parts I had and I think I need those bits - build chronicles.
After a good five years of gathering all the Losi JRX parts I could manage, I have finally decided that enough is enough...I just have to build some so I...
Last post
My mistake Darryn. :oops: I read nerf bars, ball bearing.. and skipped to the next paragraph :( . Sorry.
Jeez mate - dont apologise at all!! No need for that - was just letting you know I hadnt ignored you at all!! :D I tend to dribble on - so I...