Nice! The price isn't bad either. I may have to order a few!
I am going to try them too, they are about 30 minutes from my house and I am just going to their office to pick up the screws. I will let you all know how it works.
Here's a project request for all the historical gurus out there:
It would be helpful to have pics and possible production dates for all the various bell crank options for the RC10s. I've known of many options in the past, but memory fades, and I'm...
Last post
I think Chris Chan from Hong Kong sold those out of the BST.
Hey Al,
is this camlchris? I was thinkin it was one of the pancar guys but can't find the thread about getting these made. He had a thread first somewhere and then went thru the b/s/t...
Yesterday I was out running in the street with my neighbor who just got his electric traxxas rustler for Christmas. We drag raced and I beat him good. But we had two collisions. First head on and my battery tie down snapped and my body got cracked...
Last post
Well I ended up spending about $50 in parts on eBay. I think I got good deals though. I just need to figure out the stock wheel size because my current wheels are too big to match anything original
How do i get the bushings out of these without destroying the bell cranks...I have tried with no luck...If anyone has some with ballbearings and they want to trade for these i will be glad to swap...I have little to no tools so that is why i am...
Last post
And in the end a pair of wire cutters did the trick lol...The sharp edges got underneath the lip or flange and i was able to yank them out...Now to watch SOA and off to bed lol...Thanks for the replies fellas...
Can anyone tell me what size bearings are needed for the associated bellcrank for a gold tub ?thanks
Last post
If your talkin about the worlds bellcranks they are 1/4 x 3/8 flanged. None of the gold chassis cars came with bellcranks that would take a bearing. Most if not all aftermarket use the same size
I managed to crack the steering bell crank with a high speed cart wheel on my vintage team car. I talked to associated and the design has obviously updated the design in the last 25 years. I emailed and they said i could uae the new design with no...
Last post
As GoMachV said above, what you need are four 1/4 x 3/8 flanged bearings. Width is 1/8 . These are the same as RC10 Classic rear axle bearings.
Prices are all over the place if you use eBay, but they are easily available.
I'm having some troubles getting ball joints to thread in to my aluminum bell cranks. I can't seem to get the standard 4-40 ball joints to thread in to attatch my steering linkage. Anybody know what size thread is supposed to fit?
Last post
Keep a 4-40 tap around handy for that stuff. An 8-32 doesn't hurt either.
Hopefully the vast think tank here can come up with an answer for me.
I am trying to work on a part compatibility matrix/chart for the vintagelosi site.
Looking at the Jrx Pro manual it says the steering bell crank parts are a1505, called the...
Last post
Ok, well sorta answered my own question by going back through the part variations thread on here.
Unfortunately it looks like they did make an a1505, but the white or black ones are clearly not what came with the Jrx-Pro. The manual may say that,...