MOmo wrote:Anyone know how accurate some of these are and if they are still available?
If that IS the right arm, Im all over it like a fat kid on cake!
you are a year too late. eagledist.com is a distributor and not retail. I bought a lot of that stuff up last year through a slot car track that had an account with them. A couple months later the website rcslot.com put up a lot of the remaining items on their site. I posted up about it mid last year when it became available, and most of is sold out within a couple days once it was on the retail site. The BST only goes back a coupe months or I could show you the post.
Hello everyone. This is my first post on this forum. I'm restoring my Edinger gold pan to run at the local track once a week. I bought a set of RPM front and rear arms. The rears fit fine, however, the front arms will not fit the shock ball mount....
Last post
As for the Traxxas motor, I had that in my sons car and it works fairly well. I had to cut part of the shaft off to make it fit under the gear cover though. But it wasn't fast enough compared to my brushless Castle 5700 so I swapped it out and now...
When on the original RC10s did they go to the wider front Arms?
Thanks, Mark
Last post
Thank you for the help. Great.. Tells me what I am looking at now.
I bought an RC10 when they were first made available. We could not find any place that had them and they were very hard to get. Our Denver Colo track couldn’t even buy any. A store...
resurrected my original narrow track gold pan, converted to brushless/lipo/DSM, but otherwise stock. it's mostly a basher unless my local track has a vintage class where i stand a chance at competing in racing. i haven't looked into it yet....
Last post
A-Arm mounts aren't different, only the color and part number!
Installed a set of RPM B4 arms on my B4.1. Haven't had a chance to run them, but def beefy compared to the stock front arms!
Before
After
Last post
The rpm arms were great on a loose loamy track. No problems whatsoever. On a hard packed Clay I just didn't like the way the truck drove and the rtr arms were even worse. It was a shame cuase the truck was unstoppable with the FT arms until they...
Maybe a rookie question, but did RPM make the team/widetrack front arms in white? Not the RPM worlds conversion type, standard wide track.
Last post
I am trying to find a set of rear Andy's arms in white but that full set of RPM arms would work. If you don't move on them Bob, please pass me the info.
While rebuilding my original Worlds, I decided to swap the arms on the front and back for RPM arms. Unfortunately the ball ends of the shock do not fit in the arm. The ball is too deep for the arm.
Can I use any ball end on the shock that'll fit?
Last post
Great thanks.
I actually found those while looking and almost hit the buy button but hesitated.
i was digging through my big box of rc10 parts (some old, some aquired with resto cars). i have a odd set of white rpm arms and today was when i wondered.... could those be worlds arms ??? they are!!!!! yipeee!!!!
i will eventually stumble on a rpm...
Last post
i was watching that rear. i will eventually find a rpm rear on a junker i hope lol