Replacement Stealth Slipper/Spur

[CNA75]

Hello all. It's been quite some time since i've been on this forum but I'm delighted to be back - the reason being that my two little boys and me are enjoying racing some vibtage RC10 buggies between us.

However, the 6 gear on one of the CEs that we are using has seen better days and i have a good stealth ready to fit. But it doesn't have a spur or slipper. Does anyone know if there are current slipper/spur (48 dp) bits that i can fit to an original stealth tranny?

Thanks in advance!

[RS Chris]

Welcome back. The most common upgrade for this is to use a T4 top shaft (part #9601) with the modern slipper setup. This is also what was used on the modern RC10 re-release. Slipper pads are #9603, hubs #9604, and spring is #9605. It uses a standard 5-40 locknut to tighten it down. Several options for spur gear as well.

[AustinZ]

The challenge is that 9601s are like hen's teeth now. If they do turn up they are well over $40 shipped w tax etc, so it may be wiser to buy a complete used stealth which generally runs about $70

[CNA75]

Many thanks for the helpful responses. Do you know where i may easily find a 48dp 81 tooth spur gear that would fit both the 6 gear and the stealth transmissions? Associated, Kimbrough or Robinson Racing perhaps?
Thanks.

[AustinZ]

I generally get the spur gears from fleabay or hit up one of the RC10 fb groups