CC/12LS 4-2

[ELF-BMX]

This is a COMPOSITE CRAFT/ rc12ls with 4-2 battery cut outs.
Im a huge fan of composite craft material, wish it was available today.

[hav3rchuck]

That is just cherry.

I always wanted an rc12 as a kid. I don't know of any indoor tracks in my area that I could justify getting one either. I will just drool at everybody's awesome cars on here.

Have fun with it!!!

[ELF-BMX]

That is just cherry.

I always wanted an rc12 as a kid. I don't know of any indoor tracks in my area that I could justify getting one either. I will just drool at everybody's awesome cars on here.

Have fun with it!!!

Thank you! I only have 1 carpet track 1 hour away so it tuff sometimes but I usually just go to the local highschool running track or very smooth parking lot with cones.

[Frankentruck]

Do you do anything to protect the underside when running outside? The chassis gets scuffed up pretty easily with such low ground clear.

[folkdeath95]

Beautiful car!
What's the 3 bolt rear axle you're using?

[ELF-BMX]

Do you do anything to protect the underside when running outside? The chassis gets scuffed up pretty easily with such low ground clear.

Theres no foam on wheels, thats why it looks do low but even with foams im only sitting 1/4” higher. This us just for shelf BUT if i did run it I would definitely cover the bottom with some tough tape.

[ELF-BMX]

Beautiful car!
What's the 3 bolt rear axle you're using?

The axle is just a typical rc12l3 axle, its not era correct as the axle came out after this model but i want to use the yokomo wheels bad.

[folkdeath95]

Beautiful car!
What's the 3 bolt rear axle you're using?

The axle is just a typical rc12l3 axle, its not era correct as the axle came out after this model but i want to use the yokomo wheels bad.

Thanks. It's easier to find 3 bolts wheels, these days.
I like your threaded front axles, too. Much clever than using the E-clips, imho.