MOmo wrote:I tried fit the rims on the CVDs i have, and they appear a tad small. I think a simple pass of the 3/16 drillbit should take care of it.
MOmo
Had to do the same thing for the ones I used. I Put a 1/4 inch bit into the back of the wheel just to 'countersink' the axle hole so it would fit. Other than that they work great. Personally I really like their blue and green colors. They are just different enuf to catch the eye but arent' the so common 'neon' look that is kinda overdone IMHO. These rims seem to hold up extremely well too. In my duratrax nitro evader bx with an OS 18 they really take the abuse
Todd
Peace and professionlism.....Kabunga signing off!!!
Hello all,
My cone washers are getting a little squished, and they are backordered most places. Before I order from rc10.com or Robobugs, does anyone know of a substitute that fits the stock axles? Thanks.
JC Racing are now offering their rear 2.2 YZ10/870C wheels as a pair, so if your looking for a set for your RC10 you no longer need to buy unwanted fronts to get the rears 👍
Guys, I have an RC10B2 that I bought right when they came out. It came with 2.15 rear wheels (which are still on it). The Associated PN in my book is 9490, I recently picked up a new set of 9490 wheels and they are a little larger (2.2 ), like my...
Last post
Same wheel in 2.2, same pin and I.D. as well- works fine
I have been lurking on here reading up on how to get my CE gold tub (I wanna say 6011 because of the bushings) driving again. It is in pristine condition considering that the only reason it was not run when I was young is because my brother botched...
Last post
Got some pictures of the wheels an how they fit using the drilled out SC10 hex adapters and the mini e-revo wheels
Hello again,
Tried to search the site but the search does not like the word tire or wheel. So I was looking for tires and am I correct in assuming that I can no longer get tires for 2 rear wheels? At some point I upgraded the wheels on my original...
Any real world experience would be appreciated. Thanks.
-Scott
Last post
The CW rims will work on a DS, just need a .200 spacer after the drive pins-
Thanks Reg, I just need to sand off 0.025 from each of the CW spacers and double them up. I am going to give that a try and update when I know something. Thanks for all...
One of the two rear wheels that came with my truck has the pin striped out. Is this a common problem? Are these repairable? I thought about making a making a aluminum insert and pressing it into the hub. Has anyone else thought of or tried this...
Last post
Sorry, I should of been more specific. My mind goes a lot faster than my typing abilities!!! Mine still has the original 3 piece wheels. The wheel is not ripped up to bad. But it's bad enough where it will not work. As usual, thanks for the link....
