Jimbo302's Trucks

[Jimbo302]

With the old tires that are on it now it's not so bad. The tres are the rearmost part of the thing, so when it does hook, it can go all the way over. I'm going to look at changing up the rear shock tower due to that.
Other than that, and backing the screws out of the slipper on the first run, it was pretty good. The front tires definitely gripped better under throttle than on my stock 10T.

[Jimbo302]

Speaking of my stock 10T, I'm thinking of returning it to its stock form, with vintage electronics and selling it.
It runs so well, I'm too tempted to run it and put more wear on it.

[Jimbo302]

should be a handful to drive (SWB) but looking cool

I set them side by side and it is actually roughly the same wheelbase.

[clm]

Speaking of my stock 10T, I'm thinking of returning it to its stock form, with vintage electronics and selling it.
It runs so well, I'm too tempted to run it and put more wear on it.

Eh, pick up a rere chassis and store it away and then run the thing! A set of RPM arms should limit any breakage issues... they were made to run so let it loose!

[Morpheus]

Marvelous trucks. All nice.

[firebird1999us]

I'm doing a little tinkering with one of my 10T's.

What chassis is that? Rc Carbon Works?

[Jimbo302]

I think it's just a regular graphite chassis. I got it off an old on road car that was already mid motor.

Here's what I have so far.

[DaveM]

Team associated graphite chassis.

You can see the AE (Associated Electrics) just below the heat sink on the chassis.

Cheers, Dave.

[Jimbo302]

Yup.

[Jimbo302]

[Jimbo302]

Body mounts on.

[Jimbo302]

Eh, pick up a rere chassis and store it away and then run the thing! A set of RPM arms should limit any breakage issues... they were made to run so let it loose!

I can't help but agree with you. So, I cleaned it up,threw the new front axles in with my basher tires and wheels.
It's back together with the 550 motor, 3S, and 2.4 tx/rx.
It is a great little all white plastic runner. I need to find some rear tires to run other than the pro line dirt grips, though.

[Jimbo302]

I swapped out a hi-tech mini servo on the graphite mid motor truck and while it is much better, I feel like I need to eliminate the bell cranks to get the steering right.

[Jimbo302]

Marvelous trucks. All nice.

Thanks, I know they are junky compared to the quality vehicles on this site, but I enjoy them.

[DaveM]

Hi,

The bell cranks are in the wrong position, too far back.

Cheers, Dave.