Thanks guys. Battery wasn't 100% charged and I used it a bit setting up the electronics. Plus then I haven't driven any RC in 18 years, so 10 minutes of basement laps couldn't be avoided
I set the tekin power flex off and amps to 5.00 and it peaked in 11 min. Then I lowered the a,ps to 3 and it went another 7 min. Just barely warm. Nice.
Once I get this thing all set up and running outside I'll update and let you all know how it went. Thank so much for all the help. It's nice to see my old B3 rolling again.
So far things have been working great. With the NiMh I njust leave the power flex off and charge at 5.0
I broke out an old NiCd and charged if on power flex at 3.2 Amps. I can't believe it worked well too. Sanyo 1700 scrc. Cool that these still even work.
Best part of all this is watching my daughter learn to drive an RC. So cool.
Hey Guys! I've been updating some cars lately and I have a question. Originally, I built my RC10 Tekin conversion without the active rear suspension. I did that because at the time, I didn't have any long rear hinge pins. Fast forward 15 years and...
Last post
I built my Tekin chassis back in 2007-08. I tried to get one of the Schumacher kits for the front for the longest time. Ended up selling the car and a kit came up for sale a month later. :roll:
I think this is the first Tekin conversion I've ever seen with a body. :lol: I still have to bend some wire to mount the wing. Overall, I think this came out pretty nice. The body didn't have to be trimmed too much off the normal lines.
Last post
carloco8, I never thought of looking at a difference in thickness, I'll take a look at that when I get home. Thanks for the heads up!
I found this gem on eBay a couple of weeks ago, from what I understand the u10 was a team only esc that pre dates the g9, but it eventually was released as the g9. However I'm not sure if the internals are the exact same or if there were minor...
I just acquired a Tekin RS Pro to run 1/12th scale 1s, 17.5 class. This esc works fine when using 2s, senses, chimes everything works right away.
When hooked up to 1s on hotwire, there are no chimes when setting up radio and only led's 1 and 2, and...
Last post
Thanks again everyone for your help. I think after reading 200-300 posts on 1s powered RS Pro, I am finally getting the idea. Use the booster to power the entire receiver and use the cable from the esc into channel two (booster in aux powered from...
Hey all,anyone here point me in the direction or share with me the manual,instructions for the tekin M star esc.. Or point me to another tekin that may share the same setup calibration procedure as the m star.. Thanks everyone :mrgreen:
Last post
Not sure about the receivers but thanks for the esc pic mate....
I got this Tekin receiver with a buggy a while ago. Before getting it i never even knew Tekin made receivers :lol: Can anyone tell me if these were any good in their day, and roughly when they were being sold?
Paul.
Last post
The Tekin FM receiver was released in 1992
Tekin AM receiver
I´m not sure for AM but for FM you have to use the right crystals otherwise the system doesn´t work. I know some transmitters are using internal frequency multiplication so in reality...
