The outdrives got a quick freshening with a small file for any burrs, and a super quick polishing for surface rust. The bearings were a little tight on the outdrives as they both mic'd in exactly at 3/8", but the bearings were definitely a tic's hair larger than the trans case openings, so needed a little persuasion.Frankentruck wrote: ↑Fri Sep 02, 2022 9:00 pm Do the outdrive slots have any raised burrs on them from dogbone wear? That can make the bearings hard to press over the outdrive.
Rebuilding the 6 gear transmission.
-
morrisey0
- Approved Member
- Posts: 1733
- Joined: Wed Jan 13, 2021 2:45 pm
- Location: Richmond, VA
- Has thanked: 77 times
- Been thanked: 1762 times
Re: Rebuilding the 6 gear transmission.
I build RCs like people would have done back in the '90s ..................................... if they had 3D printers.
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 6 Replies
- 1069 Views
-
Last post by DMAT
-
- 4 Replies
- 981 Views
-
Last post by teman
-
- 3 Replies
- 659 Views
-
Last post by Westcoast10z
-
- 6 Replies
- 1239 Views
-
Last post by slow_jun
-
- 5 Replies
- 211 Views
-
Last post by Frankentruck
-
- 11 Replies
- 1541 Views
-
Last post by superfly
-
- 23 Replies
- 3366 Views
-
Last post by SteveK
-
- 3 Replies
- 663 Views
-
Last post by DMAT
Who is online
Users browsing this forum: No registered users and 7 guests